Radiometric Calibration Evaluation for FY3D MERSI-II Thermal Infrared Channels at Lake Qinghai

Lin Yan,Yonghong Hu,Yong Zhang,Xiao-Ming Li,Changyong Dou,Jun Li,Yidan Si,Lijun Zhang
DOI: https://doi.org/10.3390/rs13030466
IF: 5
2021-01-28
Remote Sensing
Abstract:The absolute radiometric accuracy of the Fengyun 3D advanced Medium Resolution Spectral Imager (FY3D MERSI-II) thermal infrared bands was evaluated using the collected field measurements and atmospheric transfer simulations during 16–22 August 2019 at Lake Qinghai. A thermal infrared radiometer equipped on an unmanned surface vehicle was used to continuously collect the water temperature. Atmospheric conditions, surface emissivity, and aerosol optical depth measured near the field experiment site were adopted by the atmospheric transfer code to calculate the parameters about the influence of atmosphere on long-wave radiation, including the path radiance and the transmittance propagated from land surface to the satellite. The radiometric calibration accuracy analysis suggests that the differences between the simulated brightness temperature and satellite-based brightness temperature are −0.346 K and −0.722 K for channel 24 on 18 and 20 August, respectively, while it reaches −0.460 K and −1.036 K for channel 25 on 18 and 20 August, respectively. The vicarious calibration coefficients were found to be in good agreement with the internal onboard calibration coefficient in channel 24 and 25 of the FY3D MERSI-II according to the validation analysis in selected regions. The thermal infrared bands of the FY3D have a good in-orbit operational status according to our vicarious calibration experiments.
environmental sciences,imaging science & photographic technology,remote sensing,geosciences, multidisciplinary
What problem does this paper attempt to address?
### Problems Addressed by the Paper The paper primarily addresses the issue of evaluating the absolute radiometric calibration accuracy of the thermal infrared bands of the Medium Resolution Spectral Imager (MERSI-II) on the Fengyun-3D (FY3D) satellite. Specifically: 1. **Evaluating the Radiometric Calibration Accuracy of the Thermal Infrared Bands**: - Using field measurement data and atmospheric transmission simulation results collected at Qinghai Lake from August 16 to 22, 2019, to assess the absolute radiometric calibration accuracy of the FY3D MERSI-II thermal infrared bands. 2. **Validating Radiometric Calibration Coefficients**: - By comparing with the brightness temperatures observed by the satellite, the field radiometric calibration coefficients were validated, and it was found that these coefficients are in good agreement with the internal on-orbit calibration coefficients. 3. **Analyzing Radiometric Calibration Errors**: - The study found that on August 18 and August 20, the differences between the simulated brightness temperatures and the satellite observed brightness temperatures for channel 24 were -0.346 K and -0.722 K, respectively; while for channel 25, the differences were -0.460 K and -1.036 K, respectively. This discrepancy may be related to thin cloud contamination. 4. **Improving Radiometric Calibration Accuracy**: - By adopting a spectral matching method, the accuracy of radiometric calibration was significantly improved. For example, for channel 24, on August 18 and August 20, the differences after spectral matching were reduced from 0.629 K to -0.346 K, and from 0.253 K to -0.722 K, respectively. Through these studies, the paper aims to ensure the long-term radiometric calibration accuracy of the FY3D MERSI-II thermal infrared bands, thereby better supporting research on environmental evolution and climate change.