Abstract:Because several abnormal incidents involving the loss of the residual heat removal (RHR) system during refueling and maintenance outages have occurred in pressurized water reactors, the importance of investigating the physical phenomena with respect to these events has been recognized. RHR cooling is a major means to remove core decay heat after a reactor power plant shutdown. If the RHR system is lost and an alternate means for heat removal cannot be established in time, the core will boil off, and the primary system will be pressurized, which potentially results in uncovering of the fuel rods and failure of the temporary boundaries. The objective of this paper is to simulate the Maanshan nuclear power plant (MNPP) responses to the loss of the RHR system during midloop operation under variable outage conditions. Without gravity feed, the current investigation concentrates on the effects of different liquid levels, the existence of vents, and the number of active steam generators.Based on the simulated results, the total hear removal capability of one active steam generator and the pressurizer venting process is sufficient to remove core decay heat of 11.1 MW which corresponds to the power level 3 days after plant shutdown, in the event that RHR cooling fails during midloop operation. The primary system will be stabilized, and the pressure throughout the transient will nor exceed the design pressure of the nozzle darns or the temporary seals. The heat removal capability of the pressurizer vent plays a crucial role in system pressurization during loss of RHR and in the severity of this event, as shown by the calculated results of the open and closed MNPP, respectively. If only one or two active steam generators serve as an alternate cooling means, the increased pressure will exceed the design criteria of the temporary low-pressure boundaries. Then, for the closed conditions of MNPP, the loss-of-RHR event during midloop operation has the potential to induce another loss-of-coolant accident and to cause more serious consequences.

Evaluation of Non-Condensable Gas Effect On The Operation of Emergency Core Cooling System During LBLOCA

An alternative cooling solution during loss of coolant accident with emergency core cooling system failure in NUSCALE nuclear reactor

Simulation of VVER-1000 Guillotine Large Break Loss of Coolant Accident Using RELAP5/SCDAPSIM/MOD3.5

Safety Analysis in VVER-1000 Due to Large-Break Loss-of-Coolant Accident and Station Blackout Transient Using RELAP5/SCDAPSIM/MOD3.5

Comprehensive Safety Analysis Code System for Nuclear Fusion Reactors III: Ex-Vessel LOCA Analyses Considering Passive Safety

Analysis Of Effects Of Buoyancy Force On Steam Condensation With Non-Condensable Gases In A Rectangular Channel

THE CMT SIMULATION ON THE LARGE IMPASSIVE PWR WITH RELAP 5

Analysis of AP1000 Containment Passive Cooling System During a Loss-of-coolant Accident

Assessment of steam condensation model with the presence of non-condensable gas in a vertical tube using RELAP5 Mod 3.2 code and MIT exp. Data

Investigation of System Responses of the Maanshan Nuclear Power Plant to the Loss of Residual Heat Removal During Midloop Operation Using a RELAP5/MOD3 Simulation

Experimental Investigation of Early Initiation of Primary Cooldown by Secondary-Side Depressurization in A Pwr Inadequate Core-Cooling Accident

Validation of EPG/SAG Rev. 4 of the Kuosheng Nuclear Power Plant Using the MAAP5 Code

THE EFFECTS OF A NON-CONDENSABLE GAS ON PRESSURIZER INSURGE TRANSIENTS UNDER THE HIGH PRESSURE

Numerical Simulation Analysis on the Flow Mechanism of Passive Containment Cooling System

Simulations of ecc safety injection for single phase and stratified phase flow

Failure simulation of nuclear pressure vessel under LBLOCA scenarios

Effect of Coolant Water Temperature of Emergency Core Cooling System on Failure Probability of Reactor Pressure Vessel

Analyses of ACME integral test results on CAP1400 small-break loss-of-coolant-accident transient

Experimental Research on Non-Condensable Gases Effects in Passive Decay Heat Removal System

Numerical Simulation of AP1000 LBLOCA with SCDAP/RELAP 4.0 Code

The Numerical Simulation Research of Gas–Liquid Two-Phase Flow in Small-Break Loss-of-Coolant Accidents