Abstract:The prefabricated temporary house (PTH) has been widely used in various scenarios because of its convenience and environmental protection. However, PTHs are usually lightweight buildings with weak thermal inertia, resulting in poor indoor thermal comfort. Numerical research was conducted on the potential of phase change materials (PCMs) as a passive alternative to enhance the performance of the PTH throughout the year in this study. The influences of some critical factors such as thickness, phase change temperature, ventilation, building orientation, and climatic region on the thermal characteristics of PTHs were evaluated. The thermal comfort hours and energy consumption were employed as indicators to quantify the influence of PCMs on the dynamic thermal performance of PTHs. The numerical results indicated that the thickness had different effects on the PTH in different climate regions. When the total thickness of the wall was constant, I-level thermal comfort hours of the PCM rooms were higher than those of the reference room. For the Beijing area, when the wall was composed of a 100 mm insulation board, the indoor I-level thermal comfort hours were 803 h, while when the wall was composed of 90 mm insulation boards and 10 mm PCM panels, the indoor I-level thermal comfort hours increased to 1511 h. Moreover, it was worth noting that the optimal PCMs for different building orientations were basically the same, but the optimal PCMs for the PTH with and without air conditioning were different. Ventilation significantly increased thermal comfort hours and reduced energy consumption for the PTH in Guangzhou, while a larger ventilation rate would reduce the thermal comfort hours of the PTH in Kunming. In general, the numerical results supported and highlighted the potential of integrating PCM in the PTH to enhance living comfort and reduce energy consumption.

An exploration on the performance of using phase change humidity control material wallboards in office buildings

Evaluation of the Impact of Phase Change Humidity Control Material on Energy Performance of Office Buildings

Phase Change Humidity Control Material and Its Impact on Building Energy Consumption

Optimum Insulation Thickness of External Walls by Integrating Indoor Moisture Buffering Effect: a Case Study in the Hot-Summer-cold-winter Zone of China

Study on optimization of thermal property parameters of phase change wallboard and its application simulation in the building

Simulation and designing of PCM wallboard rooms combined with night ventilation

Parametric analysis of applying PCM wallboards for energy saving in high-rise lightweight buildings in Shanghai

Numerical Model of Applying PCM Boards for Energy Saving in Lightweight Buildings in Shanghai

Performance analysis of a novel phase-change wall of wood structure coupled with sky-radiation cooling

Parametric analysis of influencing factors in Phase Change Material Wallboard (PCMW)

Experimental study on the performance of an active novel vertical partition thermal storage wallboard based on composite phase change material with porous silica and microencapsulation

Numerical study on thermal comfort and energy-saving potential of a prefabricated temporary house integrated with composite phase change materials

The Reduction Of Indoor Temperature Fluctuation By Using Phase Change Materials Incorporated Inside Some Building Walls

Energy-saving potential of intermittent heating system: Influence of composite phase change wall and optimization strategy

Experimental and Numerical Investigation of Composite Phase Change Materials for Building Energy Saving

Thermal performance and economy of PCM foamed cement walls for buildings in different climate zones

Energy, Economic and Environmental (3E) Analysis of Residential Building Walls Enhanced with Phase Change Materials

Moisture transfer characteristics of the wall with phase change material

Experimental investigation on the hygrothermal behavior of a new multilayer building envelope integrating PCM with bio-based material

Dynamic integration of phase change material in walls for enhancing building thermal performance—A novel self-adaptive method for moving PCM layer

Experimental study on the performance of a novel RC-PCM-wall