Abstract:SUMMARY Marine magnetotelluric (MT) and controlled source electromagnetic (CSEM) methods have been routinely applied to survey the crustal and upper mantle electrical resistivity structures beneath the sea floor. In practice, there are inevitably site gaps and contamination by noises in the collected data because of lost ocean bottom electromagnetic receivers, unusable data, and difficulties in deploying instruments near deep trenches. So far, it remains unclear to what degree those factors will lower the resolution and the credibility of marine MT and CSEM inversion models. In this paper, we investigate the individual and combined effects of site gaps and data noises on the inversion models through synthetic analyses based on a simple block resistivity model and a realistic resistivity structure derived from the Mariana Trench. The results suggest that data with a sufficiently high signal-to-noise ratio can reasonably recover the subseafloor structures in the area of data gap. The transverse electric mode and tipper data from the MT method are much more sensitive to the structure near the site gap. The joint inversion of MT and CSEM data would improve the model's resolution at the site gap area. The inversion of data with a relatively low signal-to-noise ratio, for example, 10 per cent, can recover the structures with few artefacts if there is no site gap. But if the site gap and noisy data are combined, even a joint inversion cannot correctly recover the burial depths and geometries of the anomalous bodies beneath the site gap where vertical strips are likely present. To improve the model's resolution and suppress inversion artefacts, we propose constraining part of the model with as much a prior information as possible. Specifically, for a survey in the subduction zone, we could reduce the penalties on the model's smoothness at the upper and low interfaces of the resistive subduction slab, or even fix the resistivity of the resistive slab with the help of other information, if any. The inversion models shown in this paper provide valuable references for the site design before marine MT and CSEM surveys as well as for interpreting real data inversion models that may be subject to the same biases introduced by the site gap and noise.

Enhancing electrical structure in magnetotelluric inversion by the constraint of minimum cross-gradient support coupling

2D Magnetotelluric Inversion Using Hybrid Stabilizing Functionals: Exponential Minimum Support and Smoothness

A regularized magnetotelluric inversion with a minimum support gradient constraint

Three-dimensional Regularized Inversion of Magnetotelluric Data with a Minimum Support Gradient Constraint

A Gradient Scaling Scheme for the 3-D Magnetotelluric Inversion with Galvanic Distortion Correction

Regularized Magnetotelluric Inversion Based on a Minimum Support Gradient Stabilizing Functional

A gradient scaling scheme for the three-dimensional magnetotelluric inversion with galvanic distortion correction

Trans-dimensional Bayesian Joint Inversion of Magnetotelluric and Geomagnetic Depth Sounding Responses to Constrain Mantle Electrical Discontinuities

Structure constrained joint inversion of magnetotelluric data and receiver function

Power-Type Structural Self-Constrained Inversion Methods of Gravity and Magnetic Data

An adaptive inversion algorithm for one-dimensional magnetotelluric problems

Gravity inversion with a binary structure constraint imposed by magnetotelluric data and its application to a Carlin-type gold deposit

Joint Inversion of Multiphysical Parameters Based on a Combination of Cosine Dot-Gradient and Joint Total Variation Constraints.

Joint Inversion of Two-Dimensional Magnetotelluric and Ambient Noise Data Constrained with Cross Gradient

Geophysical Joint Inversion Based on Mixed Structural and Rock-Physics Coupling Constraints

Inversion for Magnetotelluric Data Using the Particle Swarm Optimization and Regularized Least Squares

Inversion of marine magnetotelluric and controlled source electromagnetic data with site gap and low signal-to-noise ratio

Three-dimensional Magnetotelluric Inversion Based on Multigrid Algorithm

Magnetotelluric Joint Inversion for Anisotropic Conductivities in Layered Media

An Efficient Sequential Strategy for Realizing Cross-Gradient Joint Inversion: Method and Its Application to 2-D Cross Borehole Seismic Traveltime and DC Resistivity Tomography

3D joint inversion of magnetotelluric and gravity data based on local correlation constraints