Design of dual loop controller for boost converter based on PI controller

Kifayat Ullah,Muhammad Ishaq,Muhammad Ajmal Naz,Mostafizur Rahaman,Arsalan Muhammad Soomar,Hijaz Ahmad,Md. Nur Alam

DOI: https://doi.org/10.1063/5.0191079

IF: 1.697

2024-02-01

AIP Advances

Abstract:Boost converters are widely used in industry for many applications, such as electrical vehicles, wind energy systems, and photovoltaic energy systems, to step up the low voltages. Using the topology structure of the DC–DC boost circuit, this paper studied and designed a dual loop control method based on proportional integral controllers for improving the converter efficiency. The inner loop and outer loop controls of the traditional boost circuit are adopted in MATLAB/Simulink software to make the output of the system more stable. The input voltage is set to 24 V DC, and the desired output voltage varies from 36 to 48 V. Through simulation verification, the influence of a 1 kW sudden load connection by using a switch at a nominal output voltage of 48 V DC is studied, and the results show that it reduces the transient output voltage dips during the sudden load connection. Simulation analysis verifies the design scheme of the system, reduces the fluctuation in output voltage and power, reduces the output current ripple, minimizes the dip in voltage to a minimum possible value, and improves the dynamic characteristics and overall efficiency of the converter.

materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology

What problem does this paper attempt to address?

The paper mainly addresses the following issues:

1. **Improvement in Boost Converter Efficiency**: To address the shortcomings of traditional controllers in boost converters, such as large current ripple, low system power density, and output voltage drop, a dual-loop control strategy based on a Proportional-Integral (PI) controller is proposed.

2. **Improvement in Dynamic Response and Overall Efficiency**: By designing and implementing a novel dual-loop control method, the aim is to reduce fluctuations in output voltage and power, decrease output current ripple, and minimize voltage drop to the lowest possible value, thereby enhancing the dynamic characteristics and overall efficiency of the converter.

3. **Handling Load Transients**: The study investigates how the proposed dual-loop control strategy effectively reduces transient output voltage drop when the system experiences load transients (e.g., connecting a 1 kW load), ensuring stable system operation.

Specifically, the paper conducts a simulation analysis of the DC-DC boost circuit using MATLAB/Simulink software to verify the effectiveness of the proposed control strategy. The study considers three different scenarios: fixed desired output voltage, dynamically changing output voltage (ranging from 36V to 48V), and a sudden load at the nominal output voltage (48V). The simulation results show that the proposed dual-loop control strategy can significantly improve the performance of the converter, including reducing inductor current ripple, minimizing transient effects, reducing output voltage ripple, and achieving higher conversion efficiency.