Vibrational energy harvesting and tactile sensing applications based on PVDF-TPU piezoelectric nanofibers

Tripathi, Balram,Jain, Ankur

DOI: https://doi.org/10.1007/s10854-024-12635-z

2024-04-27

Journal of Materials Science Materials in Electronics

Abstract:In the present study, mechanical vibration-based energy harnessing and sensing using electrospun piezoelectric nanofiber mat was investigated. It was developed from pure PVDF and PVDF-TPU composites. The application of this active piezo nanofiber mat in the domains of vibrational energy harvesting and wearable electronic sensors was evaluated. Analysis of the energy harvesting from basic body motions reveals that it is very effective at detecting biomechanical movements. The addition of TPU to the electroactive PVDF enhanced the output performance of the flexible nanogenerator, increased piezo-efficiency, and improved the stretchability of the nanofiber mat. A sensitivity parameter of 0.9 V/N is exhibited by the PVDF with 15 wt% TPU which is almost 2.5 times as compared to the sensitivity value of pure PVDF-based nanomat. A maximum voltage of 12 V is generated by PVDF-TPU composition, toward a falling mass of 250 g under impulse loading condition which is almost 2.4 times than that of the potential developed across pure PVDF nanomat. An enhanced piezoresponse of 5 V is shown by the PVDF-TPU composition under a bending action at right angle, which is around 3 V only under the same condition for pure PVDF nanomat. The scope of the developed prototype in the field of vibration sensing and in scavenging electrical energy from low-frequency vibrational movements of machineries was also analyzed in detail which reflected the piezoresponse voltage increasing linearly with the frequency. With the increase in frequency at different applied forces, output voltage increases linearly with the increasing force. A maximum voltage of 38 V is obtained at an applied force of 2N with a repeatability of 30 Hz frequency with a sensitivity of 15 V/ N. This PVDF-TPU composite-based prototype exhibited a power density of 39.5 mW/m 2 . The potential of these nanomats on biomechanical energy harvesting based on hand clapping and finger impartment movements was also tested. These novel elastic piezomats can be applied for vibration energy harvesting from the whole body vibration platforms, typically vibrating between 10 and 30 Hz. The present work clearly established effective sensing ability of the prototype as a tactile sensor as well as a frequency or vibration sensor.

engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied