Direct programming of confined surface phonon polariton resonators with the plasmonic phase-change material In3SbTe2

Lukas Conrads,Luis Schüler,Konstantin G. Wirth,Matthias Wuttig,Thomas Taubner
DOI: https://doi.org/10.1038/s41467-024-47841-0
IF: 16.6
2024-04-24
Nature Communications
Abstract:Abstract Tailoring light-matter interaction is essential to realize nanophotonic components. It can be achieved with surface phonon polaritons (SPhPs), an excitation of photons coupled with phonons of polar crystals, which also occur in 2d materials such as hexagonal boron nitride or anisotropic crystals. Ultra-confined resonances are observed by restricting the SPhPs to cavities. Phase-change materials (PCMs) enable non-volatile programming of these cavities based on a change in the refractive index. Recently, the plasmonic PCM In 3 SbTe 2 (IST) was introduced which can be reversibly switched from an amorphous dielectric state to a crystalline metallic one in the entire infrared to realize numerous nanoantenna geometries. However, reconfiguring SPhP resonators to modify the confined polaritons modes remains elusive. Here, we demonstrate direct programming of confined SPhP resonators by phase-switching IST on top of a polar silicon carbide crystal and investigate the strongly confined resonance modes with scanning near-field optical microscopy. Reconfiguring the size of the resonators themselves result in enhanced mode confinements up to a value of $${{{{{\boldsymbol{\lambda }}}}}}{{{{{\boldsymbol{/}}}}}}{{{{{\boldsymbol{35}}}}}}{{{{{\boldsymbol{.}}}}}}$$ λ / 35 . Finally, unconventional cavity shapes with complex field patterns are explored as well. This study is a first step towards rapid prototyping of reconfigurable SPhP resonators that can be easily transferred to hyperbolic and anisotropic 2d materials.
multidisciplinary sciences
What problem does this paper attempt to address?
The main problem that this paper attempts to solve is to directly program and re - configure surface phonon polariton (SPhP) resonators by using phase - change materials (PCM), especially In\(_3\)SbTe\(_2\) (IST), in order to achieve precise regulation of the light - matter interaction in nanophotonics. Specifically, the paper explores how to use IST to form resonant cavities of different shapes and sizes on silicon carbide (SiC) crystals, thereby achieving the modulation of SPhP modes. This method can not only change the size of the resonator, but also explore unconventional cavity shapes and their complex field patterns, which makes it possible to rapidly prototype reconfigurable SPhP resonators and can be easily transferred to hyperbolic and anisotropic two - dimensional materials. The key points of the paper include: 1. **Direct programming of SPhP resonators**: By using laser irradiation of IST on a SiC substrate, direct programming of SPhP resonators was achieved, demonstrating the creation of resonators of different shapes (such as circular, square and triangular). 2. **Modulation of mode confinement**: By adjusting the size of the resonator, the enhancement of mode confinement was studied, and in particular, stronger mode confinement was observed in smaller resonators. 3. **Exploration of unconventional cavity shapes**: In addition to the standard circular resonator, more complex cavity shapes such as square and triangular were also studied. Resonators of these shapes showed different field patterns, further demonstrating the flexibility and potential of this method. 4. **Application prospects**: The paper points out that this technique can be applied to the design of reconfigurable nanophotonic components, including metasurfaces, surface - enhanced infrared absorption (SEIRA) and new sensor technologies, improving the performance and application possibilities in these fields. In conclusion, this paper proposes an innovative method for dynamically adjusting the light - matter interaction on the nanoscale, opening up new paths for future nanophotonics research and applications.