Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Fourier spectral element for simulation of vibro-acoustic modulation caused by contact nonlinearity in the beam

Contact acoustic nonlinearity effect on the vibro-acoustic modulation of delaminated composite structures

Application of scaled boundary finite element method for vibration-based structural health monitoring of breathing cracks

Vibration Localization and Anti-Localization of Nonlinear Multi-Support Beams with Support Periodicity Defect

A Multimode Perturbation Method for Frequency Response Analysis of Nonlinearly Vibrational Beams with Periodic Parameters

A DVA-Beam Element for Dynamic Simulation of DVA-Beam System: Modeling, Validation and Application

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Static and Dynamic Analysis of Electrostatically Actuated Microcantilevers Using the Spectral Element Method

A New Hybrid Method for Mid-Frequency Vibration of Beam-Plate System under External Point Loading

Out-Of-Resonance Vibration Modulation of Ultrasound with A Nonlinear Oscillator for Microcrack Detection in A Cantilever Beam

Assessing the Severity of Fatigue Crack Using Acoustics Modulated by Hysteretic Vibration for a Cantilever Beam

Finite element analysis of smart structural implications of a beam-type artificial basilar membrane inspired sensor

Enhancement of Contact Acoustic Nonlinearity Effect in a Concrete Beam using Ambient Vibrations

Cross-correlation vibro-acoustic modulation method for damage detection

A simple method for enhanced vibration-based structural health monitoring

Spectral strip-element method for beams treated with active constrained layer damping

Potential of Non-Contact Dynamic Response Measurements for Predicting Small Size or Hidden Damages in Highly Damped Structures

Influence of Sensor Position and Low-Frequency Modal Shape on the Sensitivity of Vibro-Acoustic Modulation for Impact Damage Detection in Composite Materials

Wave Propagation Analysis in a Beam Structure Using Spectral Element Method

Time-Domain Spectral Finite Element Method for Modeling Second Harmonic Generation of Guided Waves Induced by Material, Geometric and Contact Nonlinearities in Beams

A Hybrid Multi-Scale/finite Element Method in Arbitrary Lagrangian-Eulerian Framework for Predicting Nonlinear Structural-Acoustic Responses of a Large-Deformable Beam in Fluid