Defect induced persistence photoconductivity in spray pyrolyzed ZnO thin films: Impact of Sm 3+ doping

Manu Srivathsa,BV Rajendra
DOI: https://doi.org/10.1016/j.tsf.2024.140555
IF: 2.1
2024-11-03
Thin Solid Films
Abstract:The persistent photoconductivity of the rare earth ion doped ZnO is an emerging field. The present work focuses on the effect of samarium (Sm 3+ ) ion doping on the persistence photo response behaviour ZnO host matrix. The Zn 1-x Sm x O ( x = 0.0 to 0.10) thin films were deposited on chemically cleaned glass substrates using spray pyrolysis technique. The films showed polycrystalline nature and hexagonal wurtzite structure without any impurity peaks. The Zn 0.93 Sm 0.07 O films showed maximum crystallite size of 24.2 nm and minimum dislocation density. The gradual change in the thickness of the fibrous nature was observed with the addition of Sm 3+ ions into ZnO lattice. Energy dispersive analysis of x-ray and X-ray photoelectron spectroscopy confirmed the presence of elements and its oxidation states in the deposited film respectively. The area under the curve of deconvoluted photoluminescence spectra of deposits confirmed the decrease in the various defect percentage with increase in the doping concentration of Sm 3+ ions. The photoluminescence spectra of Zn 0.93 Sm 0.07 O films showed maximum near band edge emission and minimum defects. The Zn 0.93 Sm 0.07 O films showed higher carrier concentration of 1 × 10 17 cm −3 , mobility 32 cm 2 /Vs and lower resistivity of 1 × 10 2 Ω cm due to improved film quality. The Zn 0.93 Sm 0.07 O films exhibited the current value under dark and ultraviolet light illumination was in the range of 10 −6 A and 10 −4 A respectively. The maximum photocurrent was noticed at 375 nm which corresponds to the bandgap of the deposited films. The Zn 0.93 Sm 0.07 O films showed faster photo response (5 s and 131 s of response and recovery time) due to the presence of minimum trap states. Hence the Zn 0.93 Sm 0.07 O films can be used in the fabrication of light dependent resistors and ultraviolet sensors.
materials science, multidisciplinary,physics, applied, condensed matter, coatings & films
What problem does this paper attempt to address?