Abstract:Water-based lubricants have the potential to become the largest environmentally friendly lubricants in applications such as electric vehicles and the newly emerging green technologies of the future due to their inherent low viscosity and cooling properties. In order to be environmentally acceptable (EAL), both base lubricants and additives should comply with biodegradability, non-toxicity, and non-bioaccumulation requirements. Additives for water-based lubricants should ideally be polar and soluble in water and, at the same time, should not increase the electrical conductivity to critical levels for corrosion. However, most additives used in synthetic or mineral oils are non-polar. Ionic liquids have recently gained attention as lubricant additives due to their high polarity, making them highly surface-active (i.e. high tendency to adsorb on metal surfaces). However, they are seen as highly corrosive for many metal alloys. In this work, a water-glycol lubricant containing two different ionic liquids has been investigated as a potential green lubricant for a bearing steel AISI 52100 with accurate control on electrical conductivity and pH. The selected ionic liquids were tributylmethylphosphonium dimethylphosphate (PP) and 1-butyl-1-methylpyrrolidinium tris(pentafluoroethyl)trifluorophosphate (BMP). The tribological behaviour of the ionic liquids was compared with a well-known organic friction modifier, dodecanoic acid (C12). The ionic liquids showed lower friction and wear rate than the water-based lubricant alone. However, they showed higher friction than the lubricant formulated with C12, in which PP gave lower friction than BMP due to low pH. A detailed subsurface analysis of the wear track using scanning-transmission electron microscopy (STEM) showed that a thick oxide tribofilm was built on the wear track for both lubricants formulated with ionic liquids due to high electrical conductivity. This tribofilm gave beneficial effect on wear. Although PP and BMP gave thicker tribofilms than C12, it was not durable, resulting in cracking and detachment.

Green Hydrophobic Deep Eutectic Solvents as Low-Viscosity and Efficient Lubricants

Universal and Stable Slippery Coatings: Chemical Combination Induced Adhesive-Lubricant Cooperation

Silsesquioxanes-Based Nanolubricant Additives with High Thermal Stability, Superhydrophobicity, and Self-cleaning Properties

Achieving the Good Thermal-Stability and Lubricity Via a Dihydroxy Biolubricant from the Agro-Waste of Codonopsis Pilosula

Tribological Behaviors of Some Novel Dimercaptothiadiazole Derivatives Containing Hydroxyl As Multifunctional Lubricant Additives in Biodegradable Lithium Grease

Significantly Reducing Friction and Wear of Water‐Based Fluids with Shear Thinning Bicomponent Supramolecular Hydrogels

Lubricating properties of thymol-based deep eutectic solvents

Catalyzing Green Lubricants into Graphitic Carbon Layers by Iron Single Atoms to Reduce Friction and Wear

Lubricating Properties of Polyalkylene Glycol and Organic Phosphate Ester Mixed Aqueous Solutions

Achieving Macroscale Liquid Superlubricity Using Lubricant Mixtures of Glycerol and Propanediol

Synthesis, Characterization, Tribological and Rheological Properties of Di (2-Butyloctyl) Dicarboxylate Esters for Environmentally Friendly Biolubricant Applications

Robust Superhydrophobic Membrane for Solving Water-Accelerated Fatigue of ZDDP-Containing Lubricating Oils

Layered Double Hydroxide Nanoplatelets with Excellent Tribological Properties under High Contact Pressure as Water-Based Lubricant Additives

Dynamic Covalent Polymer-Nanoparticle Networks As High-Performance Green Lubricants: Synergetic Effect in Load-Bearing Capacity

Macroscale Superlubricity with Ultralow Wear and Ultrashort Running-In Period (∼1 s) through Phytic Acid-Based Complex Green Liquid Lubricants

Preparation and Performance Evaluation of an Environmentally Friendly Lubricant for Water-based Drilling fluid

Synthesis of Polyzwitterionic Carbon Dots with Superior Friction and Fatigue Control Behaviors under Water Lubrication

Novel green waterborne polyurethane-polytetrafluoroethylene BSLCs: Chemically optimized crosslinking extent for enhancing the mechanical and tribological properties

Breaking the trade-off between oil film thickness and viscous friction – n-alcohol-containing lubricants in high-pressure contacts

Superhydrophobic Lubrication: Gas-Liquid Bilayer Reduces the Friction Between Two Solids

Ionic Liquid Additives in Water-Based Lubricants for Bearing Steel – Effect of Electrical Conductivity and pH on Surface Chemistry, Friction and Wear