Abstract:Myopia, which is the result of the uncoordinated development of the eyeball, has become a major public health focus worldwide. Laser in situ keratomileusis (LASIK) and small-incision lenticule extraction (SMILE) have been successfully used in modern corneal refractive surgery. However, there are still controversies about postoperative results of LASIK and SMILE. In this study, a three-dimensional finite element model of the cornea was constructed based on the elevation and pachymetry data of a female volunteer. Surgical parameters, magnitudes of myopic correction, and intraocular pressure (IOP) were varied. Furthermore, an iterative algorithm was applied to retrieve the free-stress state of the intact corneal model, LASIK model, and SMILE model. To better evaluate the differences between LASIK and SMILE procedures, the displacement and Von Mises stress on the anterior and posterior corneal surface along the x- and y -axes were analyzed. Results for the zero-pressure model showed larger displacement compared to the image-based corneal model, suggesting that the initial corneal pre-stress stiffens the response of the cornea, both in the intact cornea and under refractive surgery. In addition, the displacement on the corneal surface in LASIK (both zero-pressure and image-based model) was obviously higher than that of the SMILE model. In contrast, SMILE increased Von Mises stress in the corneal cap and reduced Von Mises stress in the residual stromal bed compared with the LASIK model. However, the maximum Von Mises stress in the SMILE model was still smaller than that of the LASIK model. Moreover, the displacement and Von Mises stress on the residual stromal bed increased linearly with IOP. Overall, LASIK and SMILE refractive surgery could change biomechanical behaviors of the cornea. Compared to LASIK refractive surgery, SMILE may present a lower risk of ectasia. Creating a corneal cap rather than a corneal flap may have an advantage in improving corneal biomechanical stability.

Introduction to Biomechanics of the Cornea

In Vivo Biomechanical Measurements of the Cornea

Biomechanics of corneal ectasia and biomechanical treatments

Biomechanics of Corneal Ring Implants

Progress on the measurement of corneal biomechanical properties

Biomechanical Simulation of Stress Concentration and Intraocular Pressure in Corneas Subjected to Myopic Refractive Surgical Procedures

The Biomechanical Response of the Cornea in Orthokeratology

Assessment of Biomechanical Properties for Corneal Post Refractive Surgery

Biomechanical model of cornea deformation and simulation

Current advance on corneal biomechanical research

Biomechanical and refractive behaviors of keratoconic cornea based on three-dimensional anisotropic hyperelastic models.

A review of human cornea finite element modeling: geometry modeling, constitutive modeling, and outlooks

Finite Element Analysis of Determining Corneal Biomechanical Properties in Vivo Based on Corvis ST

Corneal biomechanics and diagnostics: a review

Analytic Modeling and Simulating of the Cornea with Finite Element Method

Effects of Laser In Situ Keratomileusis and Small-Incision Lenticule Extraction on Corneal Biomechanical Behavior: A Finite Element Analysis

A Comprehensive Study on Elasticity and Viscosity in Biomechanics and Optical Properties of the Living Human Cornea

A discrete-to-continuum model for the human cornea with application to keratoconus

New forays into measurement of ocular biomechanics

3D bioprinting for artificial cornea: Challenges and perspectives.

[Advances in Biomechanical Effects of Laser Corneal Refractive Surgery].