Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Theoretical model and control-parameter classification analysis for solid oxide fuel cell systems with cooling air bypass into burner

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

A Predictive Model Of Solid Oxide Fuel Cell Stacks For Thermal Mangement

Afterburner temperature safety assessment for solid oxide fuel cell system based on computational fluid dynamics

Numerical analysis of afterburner chamber design for solid oxide fuel cell system

Experimental and modeling study of full- condition combustion characteristics of exhaust gas burners for solid oxide fuel cells

Experimental investigation of temperature distribution in solid oxide fuel cells

A Reduced-Order Electrochemical Model for Analyzing Temperature Distributions in a Tubular Solid Oxide Fuel Cell Stack

An Optimization and Fast Load-Oriented Control for Current-Based Solid Oxide Fuel Cell System

Control Loop Design and Control Performance Study on Direct Internal Reforming Solid Oxide Fuel Cell

Investigation of Thermal Radiation Effects on Solid Oxide Fuel Cell Performance by A Comprehensive Model

A Comprehensive Review of Thermal Management in Solid Oxide Fuel Cells: Focus on Burners, Heat Exchangers, and Strategies

Modeling Analysis of SOFC System Oriented to Working Condition Identification

Experimental study of a solid oxide fuel cell afterburner for a 30 kW generator module: A comparative performance analysis

Evaluating the effectiveness of the modified multi-scale multi-physics coupled model for solid oxide fuel cells: A comparative analysis

Modeling and control-oriented thermal safety analysis for mode switching process of reversible solid oxide cell system

Modeling of SOFC System Reduction and Simulation Testing

Temperature Model and Predictive Control for Fuel Cells in Switcher Locomotive

Structure optimization and thermal field analysis of biogas derived methane fueled Solid Oxide Fuel Cell

Constrained Predictive Controller Design Based on Fuel Exhaustion and Thermal Constraints of A 5 kW SOFC Stack

Thermal Stress in Full-Size Solid Oxide Fuel Cell Stacks by Multi-Physics Modeling