Abstract:Sample preparation procedures are in most cases sample- and time-consuming and commonly require the use of a large amount of solvents. Automation in this regard can optimize the minimal-needed injection volume and the solvent consumption will be efficiently reduced. A new fully automated sample desalting and pre-concentration technique employing microextraction by packed sorbents (MEPS) cartridges is implemented and coupled to an ion cyclotron resonance Fourier-transform mass spectrometer (ICR-FT/MS). The performance of non-target mass spectrometric analysis is compared for the automated versus off-line sample preparation for several samples of aqueous natural organic matter. This approach can be generalized for any metabolite profiling or metabolome analysis of biological materials but was optimized herein using a well characterized but highly complex organic mixture: a surface water and its well-characterized natural organic matter and a marine sample having a highly salt charge and enabling to validate the presented automatic system for salty samples. The analysis of Suwannee River water showed selective C18-MEPS enrichment of chemical signatures with average H/C and O/C elemental ratios and loss of both highly polar and highly aromatic structures from the original sample. Automated on-line application to marine samples showed desalting and different chemical signatures from surface to bottom water. Relative comparison of structural footprints with the C18-concentration/desalting procedure however enabled to demonstrate that the surface water film was more concentrated in surface-active components of natural (fatty acids) and anthropogenic origin (sulfur-containing surfactants). Overall, the relative standard deviation distribution in terms of peak intensity was improved by automating the proposed on-line method.FigureThe efficient use of MEPS technique in automated form with high resolution FT-ICR-MS gives a selective spectrum, which reveals rich see water organic content. The shown high sensitivity of detected organic matter is due to effective desalting achieved by automated MEPS coupling to FT-ICR-MS technique.

Automated membrane-based sampling and sample preparation exploiting flow-injection analysis

Direct Processing and Analysis of Solid and Other Complex Samples with Automatic Flow Injection Systems

Recent Advances in Membrane-Aided Extraction and Separation for Analytical Purposes

Trends of Flow Injection Sample Pretreatment Approaching the New Millennium

Innovative Configurations of Sample Preparation Techniques Applied in Bioanalytical Chemistry: A Review

An unsegmented extraction system for flow injection analysis

Exploiting Flow-Based Separation Techniques for Sample Handling in Wine Analysis

Time-based and volume-based sampling for flow-injection on-line sorbent extraction graphite furnace atomic absorption spectrometry

Automated microextraction sample preparation coupled on-line to FT-ICR-MS: application to desalting and concentration of river and marine dissolved organic matter

Developments in protein assays with flow injection/sequential injection techniques

Determination of drugs in biological fluids by direct injection of samples for liquid-chromatographic analysis

On- Line Sample Pre- Treatment Techniques Coupled with Micro Liquid Chromatography- Solid- Phase Microextraction and Membrane Extraction

Modern automated sample preparation for the determination of organic compounds: A review on robotic and on-flow systems

Automated Continuous Monitoring of Drug Dissolution Process Using a Flow Injection On-Line Dialysis Sampling – Solvent Extraction Separation Spectrophotometric System

Automated deep eutectic solvent-based chromatomembrane microextraction: Separation and preconcentration of bisphenols from aqueous samples

Flow-Injection Methods in Water Analysis—Recent Developments

Sample preparation for the analysis of volatile organic compounds in air and water matrices

Recent progress of microfluidic sample preparation techniques

Trends and perspectives of flow injection/sequential injection on-line sample-pretreatment schemes coupled to ETAAS

Developments in Flow Injection—Capillary Electrophoresis Systems