Development and Optimization of Dipyridamole- and Roflumilast-Loaded Nanoemulsion and Nanoemulgel for Enhanced Skin Permeation: Formulation, Characterization, and In Vitro Assessment

Zeyad Khalaf Maded,Souad Sfar,Ghada Abd Alrhman Taqa,Mohamed Ali Lassoued,Olfa Ben Hadj Ayed,Hayder Adnan Fawzi

DOI: https://doi.org/10.3390/ph17060803

IF: 4.6

2024-06-20

Pharmaceuticals

Abstract:This study explores developing and optimizing a nanoemulsion (NE) system loaded with dipyridamole and roflumilast, aiming to improve skin penetration and retention. The NE formulation was further transformed into a nanoemulgel to enhance its application as a topical treatment for psoriasis. Solubility studies were conducted to select the oil, surfactant, and co-surfactant. Phase diagrams were constructed using the aqueous phase titration method. All the formulations were in nanoscale, and Formula (F2) (which contains oleic acid oil as the oil phase, a mixture of Surfactant Tween 80 and co-surfactant (ethanol) at a ratio of 1:2 in addition to distilled water as an aqueous phase in a ratio of 1:5:4, respectively) was the selected formula depending on the particle size, PDI, and zeta potential. Formula (F2) has the best ratio because it gives the smallest nanoemulsion globule size (particle size average of 167.1 nm), the best homogenicity (lowest PDI of 0.195), and the highest stability (higher zeta potential of −32.22). The selected formula was converted into a nanoemulgel by the addition of 0.5% (w/w) xanthan gum (average particle size of 172.7 nm) and the best homogenicity (lowest PDI of 0.121%) and highest stability (higher zeta potential of −28.31). In conclusion, the selected formula has accepted physical and chemical properties, which enhanced skin penetration.

pharmacology & pharmacy,chemistry, medicinal

What problem does this paper attempt to address?

This paper aims to develop and optimize a nanoemulsion and nanogel system containing dipyridamole and roflumilast to enhance the skin permeability and retention of the drugs for the treatment of psoriasis. The study selected suitable oil phase, emulsifier, and co-emulsifier through dissolution experiments and constructed a pseudo-ternary phase diagram to determine the optimal formulation. The final selected formulation (F2) had the smallest nanoemulsion droplet size (average particle size of 167.1 nm), the best uniformity (lowest PDI value of 0.195), and the highest stability (higher Zeta potential of −32.22). Additionally, this nanoemulsion was further converted into a nanogel containing 0.5% xanthan gum, which further improved its physicochemical properties and skin penetration ability. The study also evaluated the in vitro skin permeability using a Franz diffusion cell.