A comparison of calculation methods for the diffusion coefficient as a potential tool for identifying material alteration with time

Hamad Raheem,Bernadette Craster,Ashwin Seshia

DOI: https://doi.org/10.1016/j.polymertesting.2024.108356

IF: 5.1

2024-02-12

Polymer Testing

Abstract:This article addresses the calculation of diffusion coefficients of CO 2 gas through PE-RT from continuous sweep permeation tests after different run times. Knowing the permeability and diffusion coefficients allows the solubility and concentration in the polymer film to be calculated. Other permeation methods used more often in engineering applications such as the closed cell manometric method traditionally provide estimates of the lag time diffusion coefficient often after just hours of first exposure. In Raheem et al. the potential for inferring alterations in morphology from the diffusion and permeability coefficients was raised. The previous study (Raheem et al., 2022) [1], covered analysis of permeation, diffusion and solubility coefficients, activation energies and crystallinity alterations to infer ageing attributes in polymers exposed to gaseous and supercritical CO 2 and H 2 . The lag-time method of calculation of the diffusion coefficient was applied when steady-state was reached. This study investigates methods such as those fitting the transients like the Taylor expansion, inflection of the first derivative of the flux, and variations in the calculations of the diffusion coefficient using chosen times in the flux curve (e.g., time-lag, half-point flux, Yen Shih method and similar fits). These can be implemented at various stages in the development of the permeation trace over several weeks. The time-lag method was compared to the other published methods to verify its effectiveness as a convenient technique for engineers to accurately estimate single gas diffusion in polymer films. It was found that the time-lag method ranged in agreement with the other published methods from less than 1% to up to 27%. The approaches presented support the study of transport coefficients employed for detecting alterations in polymeric structures. Consequentially, l iterature validation of the feasibility of detecting alterations in material structure, i.e., physical ageing through the monitor of the diffusion coefficient is reported in this communication.

materials science, characterization & testing,polymer science