Abstract:Lithium and sodium-ion batteries have become the focal point of interest for the energy transition due to their promising applications for electric cars and energy grid storage. Operando characterization of batteries is critical to understand the degradation processes and increasing their electrochemical performance, especially in abusive conditions like during fast charges. Knowledge of the redox state of each electrode is essential to identify the origins of capacity loss in full batteries. Among the methods used for these investigations, operando Nuclear Magnetic Resonance (NMR) methods are promising since, without destroying the battery, they enable monitoring in real-time the electrochemical processes and the formation of short-lived metastable or reactive phases [1,2]. Up to now, most operando NMR studies have focused on 7 Li NMR spectroscopy to follow the lithiation and degradation processes in the solid electrodes of lithium-ion batteries. However, the large shifts and broadenings of the NMR spectra, which result from the redox-active paramagnetic ions (Ni 2/3+ , Co 4+ , Mn 3/4+ ) or from the metallicity of the electrodes [3], complicate operando NMR spectra acquisition and interpretation for full batteries. Herein, we demonstrate that the 1 H operando NMR signal of the liquid electrolyte solvent can be used to spy on the positive electrode evolution while benefitting from the high sensitivity of 1 H liquid-state NMR compared to 7 Li NMR. So far, operando NMR using the liquid electrolyte signal was mainly exploited to follow electrolyte decomposition [4] or to image indirectly dendrite formation [5]. Contrary to the lithium or sodium atoms composing the electrodes, hydrogen atoms in the electrolyte solvent are not a direct probe of the state of charge of the electrode. We demonstrate that the 1 H NMR signal of the electrolyte molecules in the battery is, however, highly sensitive to the magnetic susceptibility (and therefore the redox state) of the neighboring particles of positive electrode active material. The state-of-charge (SOC) of the positive electrodes in the charging battery can be tracked indirectly through distortion in the spectrum of the dimethyl carbonate (DMC) solvent near the positive electrode. The effect of the other battery components such as current collectors, separators, or even negative electrodes is shown to be negligible compared to the perturbations induced by the positive electrode. We define specific descriptors to track the changes in the distorted 1 H NMR spectrum of the battery and we correlate these changes with the state-of-charge of the positive electrode inside the battery as it is charged and discharged. This approach will enable measuring, operando , the redox state of positive electrodes in batteries, even when their 7 Li signals cannot be detected by NMR. Exact knowledge of the redox state will contribute to a better exploitation of the electrochemical curves in full batteries. [1] Bagheri, K.; Deschamps, M.; Salager, E. Nuclear Magnetic Resonance for Interfaces in Rechargeable Batteries. Current Opinion in Colloid & Interface Science 2023, 64, 101675. https://doi.org/10.1016/j.cocis.2022.101675. [2] Liu, X.; Liang, Z.; Xiang, Y.; Lin, M.; Li, Q.; Liu, Z.; Zhong, G.; Fu, R.; Yang, Y. Solid‐State NMR and MRI Spectroscopy for Li/Na Batteries: Materials, Interface, and in Situ Characterization. Advanced Materials 2021, 33 (50), 2005878. https://doi.org/10.1002/adma.202005878. [3] Grey, C. P.; Dupré, N. NMR Studies of Cathode Materials for Lithium-Ion Rechargeable Batteries. Chemical Reviews 2004, 104 (10), 4493–4512. https://doi.org/10.1021/cr020734p. [4] Wiemers-Meyer, S.; Winter, M.; Nowak, S. NMR as a Powerful Tool to Study Lithium Ion Battery Electrolytes. Annual Reports on NMR Spectroscopy 2019, 121–162. https://doi.org/10.1016/bs.arnmr.2018.12.003. [5] Ilott, A. J.; Mohammadi, M.; Chang, H. J.; Grey, C. P.; Jerschow, A. Real-Time 3D Imaging of Microstructure Growth in Battery Cells Using Indirect MRI. Proceedings of the National Academy of Sciences 2016, 113 (39), 10779–10784. https://doi.org/10.1073/pnas.1607903113.

3-Electrode Setup for the Operando Detection of Side Reactions in Li-Ion Batteries: The Quantification of Released Lattice Oxygen and Transition Metal Ions from NCA

Coupling Liquid Electrochemical TEM and Mass‐Spectrometry to Investigate Electrochemical Reactions Occurring in a Na‐Ion Battery Anode

Coupling liquid electrochemical TEM and mass-spectrometry to investigate electrochemical reactions occurring in a Na-ion battery anode

Electrochemical Scanning Probe Microscopy Evaluation of Li-Ion Battery Cathode Degradation through in Situ Oxygen Evolution Measurement and Interfacial Property Characterization

Novel Operando Nuclear Magnetic Resonance Approach for Tracking the Electrode State of Charge in Li/Na-Ion Batteries

On the Formation of a Cathode Electrolyte Interphase on High Voltage Li-ion Cathodes

Combining X-ray Nano-CT and XANES Techniques for 3D Operando Monitoring of Lithiation Spatial Composition evolution in NMC Electrode

Operando Hard X-Ray Photoelectron Spectroscopy for Observing Interfacial Electrochemical Reactions in All-Solid-State Batteries

Anodic Oxidation of Conductive Carbon and Ethylene Carbonate in High-Voltage Li-Ion Batteries Quantified by On-Line Electrochemical Mass Spectrometry

In Situ Investigation of Lattice Oxygen Loss from Preferentially Faceted Electrodeposited LiCoO 2 via Scanning Electrochemical Microscopy

Operando gas chromatography mass spectrometry for the continuous study of overcharge-induced electrolyte decomposition in lithium-ion batteries

Novel Method for Monitoring the Electrochemical Capacitance by In Situ Impedance Spectroscopy as Indicator for Particle Cracking of Nickel-Rich NCMs: Part II. Effect of Oxygen Release Dependent on Particle Morphology

Design of an Online Electrochemical Mass Spectrometry System to Study Gas Evolution from Cells with Lean and Volatile Electrolytes

(Digital Presentation) Chemical Workflow of Characterizing Lithium-Ion Battery Electrodes: From SEM-Eds PCA and FIB Tof-SIMS Analysis to XPS

Monitoring the Electrochemical Capacitance By in Situ Impedance Spectroscopy As Indicator for Particle Cracking of (Nickel-Rich) Cathode Active Materials: Development of a Simplified Measurement Setup

In situ AFM visualization of Li-O2 battery discharge products during redox cycling in an atmospherically controlled sample cell

Observation and quantification of nanoscale processes in lithium batteries by operando electrochemical (S)TEM

The redox mediated - scanning droplet cell system for evaluation of the solid electrolyte interphase in Li-ion batteries

Nanoscale (PEEM) Spectroscopy Combined with XPS to Elucidate the Surface Reaction Mechanism of Cycled Battery Electrodes

Operando NMR of NMC811/Graphite Lithium-Ion Batteries: Structure, Dynamics, and Lithium Metal Deposition.