Abstract:The application of Fe3+ and NH4 + in the flotation separation of chalcopyrite and arsenopyrite were investigated by micro-flotation tests, infrared spectroscopy, local electrochemical impedance spectroscopy, X-ray photoelectron spectroscopy, Time-of-flight secondary ion mass spectrometry, surface adsorption experiments and inductively coupled plasma mass spectrometry. Finally, it mainly explained the interaction mechanism of Fe3+ and NH4 + on chalcopyrite surface. The micro-flotation tests showed that the combined use of Fe3+ and NH4 + can not only inhibit arsenopyrite but also activate chalcopyrite. The action of Fe3+ on the surface of the two minerals leads to a deeper oxidation of the mineral surface, and hydrophilic compounds are produced on the mineral surface to inhibit flotation. The X-ray photoelectron spectroscopy and surface adsorption experiments showed that after addition of NH4 +, the hydrophilic compounds on chalcopyrite surface treated with Fe3+ did not decrease, but the adsorption of xanthate significantly increased. The inductively coupled plasma mass spectrometry showed that ammonium chloride can react with the copper sites on the surface of chalcopyrite, causing a small amount of copper to dissolve. It is speculated that the mechanism is that it reacts with Cu sites on the surface of chalcopyrite under the action of dissolved oxygen after the addition of ammonium chloride. The dissolved Cu2+ on the mineral surface forms a relatively stable ammoniacal copper complex ion (Cu (NH3) n 2+) with ammonium. These ammoniacal copper complex ions undergo redox reactions with xanthate, which capture the electrons in the copper ammonium complex and Cu (I) to produce cuprous xanthate and dixanthogen. Cuprous xanthate precipitates and adsorbs on the surface of the mineral, while the dixanthogen physically adsorbs around the cuprous xanthate.

Surface modification of ilmenite by introducing copper-ammonia ion and its response to flotation in H2SO4-H2O2 system

Original Data and Descriptions from Inhibition Mechanism of Ca2+, Mg2+ and Fe3+ in Fine Cassiterite Flotation Using Octanohydroxamic Acid

Selective Flotation Separation of Molybdenite from Chalcopyrite by Ozone Nanobubbles Preconditioning

Behavior of Lead Ions in Cassiterite Flotation Using Octanohydroxamic Acid

Role of Humic Acid in Enhancing Dissolved Air Flotation for the Removal of Tio2 Nanoparticles

Novel Approach for Fine Ilmenite Flotation Using Hydrophobized Glass Bubbles as the Buoyant Carrier

Highly efficient flotation of ilmenite with a novel dithiocarbamate-hydroxamate collector

Enhancing flotation separation of fine copper oxide from silica by microbubble assisted hydrophobic aggregation

Inhibition Mechanism of Ca2+, Mg2+ and Fe3+ in Fine Cassiterite Flotation Using Octanohydroxamic Acid

Surface Mechanism of Fe3+ Ions on the Improvement of Fine Monazite Flotation With Octyl Hydroxamate as the Collector

Novel insights into the microstructure of Al-BHA on the surface of ilmenite

Efficient Flotation Separation of Ilmenite and Olivine in a Weak Alkaline Pulp Using a Ternary Combination Collector Centered around Al3+

A DFT-based method to determine the ammonium-induced activation and sulfidation pathway of tenorite

Effects of surface Chemistry, particle morphology and pretreatment on zircon flotation

A novel sodium trans-2-nonene hydroxamate for the flotation separation of ilmenite and forsterite: Superior collecting and selectivity

Adsorption of polystyrenesulfonate on titanaugite surface: Experiments and quantum chemical calculations

Activation mechanism of ammonium oxalate with pyrite in the lime system and its response to flotation separation of pyrite from arsenopyrite

Novel insights into the influence of ferric ion as a surface modifier to enhance the floatability of specularite

The interaction mechanism of Fe3+ and NH4+ on chalcopyrite surface and its response to flotation separation of chalcopyrite from arsenopyrite

Depression effect of acid surface pretreatment on the flotation behaviors of four classified titanaugites

Adsorption performance and mechanism of the commonly used collectors with Oxygen-containing functional group on the ilmenite surface: A DFT study