Abstract:A solar tracker significantly increases the amount of energy harvested by a floating photovoltaic system by adjusting the pose of its photovoltaic (PV) panels to optimize their exposure to the solar rays. Conventional solar trackers perform such an adjustment using actuators, which is energy-consuming and involves complex structures. In this paper, a novel dual-axis wave-driven solar tracker is proposed where the photovoltaic (PV) panel is adjusted by the inertia force and gravity. Actuators are replaced by brakes to fix the pose of the PV panel. The kinematics and dynamics of the system are investigated, which are further used for the state feedback and the formulation of the control strategy. A sliding-mode observer is used to estimate the effect of winds on the system, which enables the robustness of the system to be enhanced. A motion planning strategy is also developed to track the solar position and minimize the movements of two joints. Indoor experiments are conducted to test the accuracy of the state feedback and dynamic model. The performance of the uncertainty observer is also tested by experiments. At last, field experiments on the real water surface are implemented to verify the feasibility of the proposed system. The results show that the solar tracker is able to adjust the PV panels at a velocity of 8.89 deg/s under the effect of limited base motions with amplitude less than 4°. Note to Practitioners—Traditional solar trackers can be driven passively by chemical energy or actively using actuators. The former cannot function stably in the field environment, and the latter is complex in structure and energy-consuming. For the FPV system under the effect of waves, the solar tracker can utilize the motion of the base to align its PV panel to the solar position. Thus, we present a wave-driven solar tracker without using actuators, and brakes are applied to lock the position of joints. The proposed solar tracker is ener- y-efficient, has a simpler structure and hardware than the active one, and is more robust than the passive one. We model the system and propose a control scheme to drive the PV panel using inertia and gravity. We also observe the effect of winds to enhance the system robustness. The motion planning strategy is investigated to minimize the movements of the joints. The impact of base motion and control period on the energy-harvesting efficiency is analyzed by simulations. Both indoor and field experiments are implemented to verify the feasibility of the system. The experimental results show that the system performs well even when the base shacking is less than 4°. Note that the control algorithm is a model-based algorithm, which means the model parameters (inertia, gravity, etc.) need to be reidentified for different PV panels and system properties. That is a challenge for large-scale deployment with different configurations. Future research will address the system identification problem and enable the model parameters to be updated automatically.

Novel approach to sandstorm-resilient solar tracking system for optimal energy generation

Dust Mitigation on Solar Panels in the Desert Environment by Single-Phase Electro-Dynamic Dust Shield: Optimization Using Electrical and Geometrical Parameters

Energy Efficiency Improvement in Photovoltaic Installation Using a Twin-Axis Solar Tracking Mechanism with LDR Sensors Compared with Neuro-Fuzzy Adaptive Inference Structure

Numerical simulation study on the impact of wind-blown sand action on the loading of photovoltaic systems

Performance of a crystalline silicon photovoltaic power plant during sandstorms

Effects of sandstorms on hybrid renewable energy sources and load demand in arid desert climates: A case study

Design and Control of a Wave-Driven Solar Tracker

Design and performance study of a dual-axis solar tracker system for the climate of Eastern Libya

Computer-based solar tracking system for PV energy yield improvement

A Control Process for Active Solar-Tracking Systems for Photovoltaic Technology and the Circuit Layout Necessary for the Implementation of the Method

Revolutionizing Photovoltaic Systems: An Innovative Approach to Maximum Power Point Tracking Using Enhanced Dandelion Optimizer in Partial Shading Conditions

Recent Advancements and Challenges in Solar Tracking Systems (STS): A Review

Microcontroller based automatic dual axis solar tracking and cleaning system

Improving Solar Panel Efficiency by Solar Tracking and Tilt Angle Optimization with Deep Learning

Developing the Design of Single-Axis Sun Sensor Solar Tracking System

Dual axis solar photovoltaic trackers: An in-depth review

A Sensorless Intelligent System to Detect Dust on PV Panels for Optimized Cleaning Units

Experimental Study on the Effect of Sand and Dust on the Performance of Photovoltaic Modules in Desert Areas

Modeling the Effect of Dust and Wind Speed on Solar Panel Performance in Iraq

Development and evaluation of a microcontrolled solar tracker based on chronological positioning