Spatial–Temporal Variation of Soil Sliding Probability in Cohesive Slopes with Spatially Variable Soils

Zhengwen Qin,Yu Wang,Xin Liu,Liang Li

DOI: https://doi.org/10.1061/(asce)gm.1943-5622.0001931

IF: 3.918

2020-12-18

International Journal of Geomechanics

Abstract:Landslide is a common and severe geohazard that may pose significant risk to adjacent structures such as buildings and buried pipelines. Identification of the failure slip surface is critical for the assessment and management of landslide risk on adjacent structures since the structures are adversely affected by large deformation of soil when landslides occur and they are not located far away from the failure slip surface and sliding soil mass. Previous studies showed that the location of the failure slip surface may change during the failure process of a slope, but the failure slip surface identified by the commonly used limit equilibrium method (LEM) only corresponds to the initiation of slope failure. In addition, soil properties vary spatially, and such variability may have a significant influence on the location or spatial distribution of the failure slip surface. In this study, a sliding probability is proposed for a soil element within a slope, and the spatial–temporal variation in the sliding probability within a cohesive slope is explored to investigate evolution of the spatial distribution of the failure slip surface during the entire process of a landslide. The investigation is performed using Monte Carlo simulations integrated with smoothed particle hydrodynamics. The soil sliding probability at each location within a slope is estimated at each stage of the failure process and used subsequently in the assessment and management of landslide risk on adjacent structures.

engineering, geological

What problem does this paper attempt to address?

The paper attempts to address the issue of the impact of the spatio-temporal variation of the sliding surface during a landslide on the risk assessment of nearby structures. Specifically:

1. **Variation of the sliding surface**: Traditional Limit Equilibrium Methods (LEM) can only determine the critical sliding surface at the onset of a landslide and cannot account for the changes in the sliding surface throughout the entire landslide process. Additionally, while Finite Element Methods (FEM) and Finite Difference Methods (FDM) can identify high plastic strain regions as sliding surfaces, they may encounter mesh distortion problems when dealing with large deformation issues.

2. **Spatial variability of soil properties**: Soil properties vary spatially, and this variation can affect the distribution of the sliding surface location. However, traditional methods have not fully considered this factor.

The paper proposes a new method—Random Smooth Particle Hydrodynamics (RSPH), which combines Monte Carlo Simulation (MCS) and Smooth Particle Hydrodynamics (SPH) to simulate the entire landslide process and study the spatio-temporal variation of sliding probability. This method allows for a better assessment of the risk of landslides to nearby structures.