Analytical Modeling of Riveting Squeezing Force Considering Non-Uniform Deformation of Rivets in Aeronautical Structures

Yonggang Kang,Siren Song,Tianyu Wang,Shuaijia Kou,Guomao Li,Yonggang Chen

DOI: https://doi.org/10.3390/ma17112756

IF: 3.4

2024-06-06

Materials

Abstract:Analytical modeling of the squeezing force for aircraft wings and fuselage panels in the existing literature usually assumes uniform deformation of the rivets, while in reality, the deformation of the rivets is non-uniform. To achieve high-quality squeezing force modeling, this paper introduces Coulomb's friction and four critical adjustments to the original equation: the non-uniform rivet/sheet interference along the sheet's hole axial ordinate; the barreling effect when calculating the driven head's volume; the spring-back of the driven head's dimensions; the modified height of the driven head; and the modified sheet-hole expanded diameter considering the convex structure of the driven head. The calculated values of the proposed new model demonstrate an improved level of accuracy, particularly under squeeze ratios commonly encountered in the aerospace industry.

materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering

What problem does this paper attempt to address?

This paper aims to solve the problems existing in the analysis models of riveting extrusion force for aircraft wing and fuselage panels in the existing literature. Specifically, existing models usually assume that the rivet is uniform during the deformation process, while in fact, the deformation of the rivet is non - uniform. This non - uniform deformation includes the barrel - shaped deformation of the rivet head and the bell - shaped deformation of the rivet shank in the hole. Therefore, the existing models based on the uniform deformation assumption may lead to over - or under - estimation of the extrusion force, because the calculated volume and diameter of the rivet head are larger, and the diameter of the rivet shank is smaller.

In order to improve the quality of extrusion force modeling, this paper introduces Coulomb friction and makes four key adjustments to the original equations:
1. Consider the non - uniformity of rivet / plate interference along the axial coordinate of the plate hole;
2. Consider the barrel - shaped effect when calculating the volume of the driving head;
3. Consider the spring - back of the driving head size;
4. Consider the plate hole expansion diameter correction of the driving head convex structure.

Through these improvements, the new model shows higher accuracy under the extrusion ratios common in the aerospace industry. The main purpose of the paper is to propose a new extrusion force calculation model by redefining the above four parameter sets to minimize the deviation from the experimental results.