Abstract:The NeuLAND (New Large-Area Neutron Detector) plastic-scintillator-based time-of-flight detector for 0.1-1.6 GeV neutrons is currently under construction at the Facility for Antiproton and Ion Research (FAIR), Darmstadt, Germany. In its final configuration, NeuLAND will consist of 3000 2.7 m $\times$ 5 cm $\times$ 5 cm big plastic scintillator bars that are read out on each end by fast timing photomultipliers. Here, data from a comprehensive study of an alternative light readout scheme using silicon photomultipliers (SiPM) are reported. For this purpose, a NeuLAND bar was instrumented on each end with a SiPM-based prototype of the same geometry as a 1'' photomultiplier tube, including four 6 $\times$ 6 mm$^2$ SiPMs, amplifiers, high voltage supply, and microcontroller. Tests were carried out using the 35 MeV electron beam from the superconducting Electron Linac for beams with high Brilliance and low Emittance (ELBE) with its picosecond-level time jitter in two different modes of operation, namely parasitic mode with one electron per bunch and single-user mode with 1-60 electrons per bunch. Acqiris fast digitisers were used for data acquisition. In addition, off-beam tests using cosmic rays and the NeuLAND data acquisition scheme have been carried out. Typical time resolutions of $\sigma_t\leq$ 120 ps were found for $\geq$95% efficiency for minimum ionising particles, improving on previous work at ELBE and exceeding the NeuLAND timing goal of $\sigma_t$ < 150 ps. Over a range of 10-300 MeV deposited energy in the NeuLAND bar, the gain was found to deviate by $\leq$10% ($\leq$20%) from linearity for 35 mm (75 mm) SiPM pitch, respectively, satisfactory for calorimetric use of the full NeuLAND detector. The dark rate of the prototype studied was found to be lower than the expected cosmic-ray induced background in NeuLAND.

Study of silicon photomultipliers for the readout of a lead/scintillating-fiber calorimeter

Study of silicon photomultipliers for the readout of a lead/scintillating-fiber calorimeter

Tests of a dual-readout fiber calorimeter with SiPM light sensors

Irradiation study of UV Silicon Photomultipliers for the Mu2e Calorimeter

Design and Performance of SiPM-based Readout of PbF2 Crystals for High-Rate, Precision Timing Applications

Study of detection efficiency distribution and areal homogeneity of SiPMs

A Novel High Dynamic-Range SiPM for Scintillator-Based Hadronic Calorimetry

Study of silicon photomultipliers for use in neutron decay experiments

Pre-production and quality assurance of the Mu2e calorimeter Silicon Photomultipliers

Study of a possible silicon photomultiplier based readout of the large plastic scintillator neutron detector NeuLAND

Silicon Photomultiplier Readout System for the ECAL in the PEBS and Test Results from the System

Future use of silicon photomultiplier for KAOS at MAMI and PANDA at FAIR

A readout system based on SiPM for the dRICH detector at the EIC

Direct Coupling of SiPMs to Scintillator Tiles for Imaging Calorimetry and Triggering

Beam test, simulation, and performance evaluation of PbF$_2$ and PWO-UF crystals with SiPM readout for a semi-homogeneous calorimeter prototype with longitudinal segmentation

R&D status for an innovative crystal calorimeter for the future Muon Collider

Study of Silicon Photomultipliers and Applications

A Design of Scintillator Tiles Read Out by Surface-Mounted SiPMs for a Future Hadron Calorimeter

Polysiloxane-based scintillators for shashlik calorimeters

Test and characterization of SiPMs for the upgrade of MEGII high resolution Timing Counter

Scintillation detectors constructed with an optimized 2x2 silicon photomultiplier array