The impact of metal centers in the M-MOF-74 series on carbon dioxide and hydrogen separation
Dominika O. Wasik,José Manuel Vicent-Luna,Azahara Luna-Triguero,David Dubbeldam,Thijs J.H. Vlugt,Sofía Calero
DOI: https://doi.org/10.1016/j.seppur.2024.126539
IF: 8.6
2024-02-07
Separation and Purification Technology
Abstract:The series of metal–organic frameworks M-MOF-74 gained popularity in the field of capture and separation of CO 2 due to the presence of numerous, highly reactive open-metal sites. The description of effective interactions between guest molecules and open-metal sites without accounting for polarization effects is challenging but it can significantly reduce the computational cost of simulations. In this study, we propose a non-polarizable force field for CO 2 , and H 2 adsorption in M-MOF-74 (M = Ni, Cu, Co, Fe, Mn, Zn) by scaling the Coulombic interactions of M-MOF-74 atoms, and Lennard-Jones interaction potentials between the center of mass of H 2 and the open-metal centers. The presented force field is based on UFF and DREIDING parameters, characterized by high transferability and efficiency. The quantum behavior of H 2 at cryogenic temperatures is considered by incorporating Feynman–Hibbs quantum corrections. To validate the force field, the experimental isotherms of CO 2 at 298 K and 10 −1 – 10 2kPa , the isotherms of H 2 at 77 K and 10 −5 – 10 2kPa , the corresponding enthalpy of adsorption, and the binding geometries in the M-MOF-74 series were reproduced using Monte Carlo simulations in the grand-canonical ensemble. The computed loadings, heats of CO 2 and H 2 adsorption, and binding geometries in M-MOF-74 are in very good agreement with the experimental values. The temperature transferability of the force field from 77 K to 87 K, and 298 K was shown for adsorption of H 2 . The validated force field was used to study the adsorption and separation of CO 2 /H 2 mixtures at 298 K. The adsorption of H 2 practically does not occur when CO 2 is present in the mixture. As indicated from simulated breakthrough curves, the breakthrough time of CO 2 in M-MOF-74 follows the same order as the uptake and the heat of CO 2 adsorption: Ni ¿ Co ¿ Fe ¿ Mn ¿ Zn ¿ Cu. Increasing the feed mole fraction of CO 2 in the breakthrough simulations from 0.1 to 0.9 speeds up the saturation of the adsorbent, leading to a faster exit of CO 2 with the column effluent. The application of the non-polarizable force field allows full investigation of the capture and separation of CO 2 in M-MOF-74, and can be expanded to study multi-component mixtures or industrial reactions in future research.
engineering, chemical