Abstract:Based on the engineering practice of large cross-section highway tunnel, this paper reveals the space-time coordinated evolution law of the construction mechanical characteristics and deformation distribution of the support structure in the construction by half bench CD method through field test. At the same time, the mechanical response calculation model of the supporting structure in the partial excavation is constructed, and the mechanical characteristics of the support structure in the partial excavation process are analyzed by above mechanical calculation model. Then, the mechanical and deformation distribution of the feet-reinforcement bolt in the steel frame—foot-reinforcement bolt combined support system is analyzed under different levels of surrounding rock load and different structural parameters of the feet-reinforcement bolt. The research results show that: (1) The internal force of the supporting structure changes most obviously during the excavation of Part I, Part II and Part III, and the internal force of the support structure gradually tends to be stable after a slight increase in the excavation of Part IV and Part V; (2) The horizontal deformation and vertical deformation of the support structure mainly occur in the excavation process of Part I, Part II and Part III, and the excavation of Part IV and V has little effect on the deformation response of the structure. The vertical displacement of the supporting structure is larger than the horizontal displacement, and the dynamic response of the temporary diaphragm structure during tunnel excavation is shrinkage-expansion-shrinkage-expansion; (3) The bending strain of each measuring point decreases with the increase of the distance from the loading point, and the bending strain of section 1 and section 2 is much larger than that of the other three sections; (4) With the increase of the angle, the section position with strain close to 0 gradually moves to the deeper position of the bolt, and the axial strain of each section on the bolt gradually changes from positive strain to negative strain.

Mechanical Behaviors of Steel Segment Support Structures for TBM-Excavated Coal Mine Tunnels: Experimental and Numerical Study

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Experiments and Numerical Simulation of the Reinforcement Effect of Channel-Steel-reinforced Shield Tunnel Segments under Unloading Conditions

Numerical study and field performance of rockbolt support schemes in TBM-excavated coal mine roadways: A case study

Full-scale Experimental and Structural Characterization Study of Shield Tunnel Reinforcement under Ground Stacking Loads

Full-scale Loading Test for Shield Tunnel Segments: Load-bearing Performance and Failure Patterns of Lining Structures

TBM Rapid Tunneling Roadway Support Parameters Design and Process Research

Study on the Stress and Deformation of Surrounding Rock and Support Structure of Super Large Section Tunnels Based on Different Excavation Methods

Mining Hazards to the Safety of Segment Lining for Tunnel Boring Machine Inclined Tunnels

Investigation on the structural behaviors of segmental tunnel with a new generalized-beam-theory-based model incorporating cross-sectional distortions

Analysis for bearing performance and construction mechanical behavior of supporting structure for the large cross-section tunnel by half bench CD method

Physical Experiment and Numerical Modeling on the Failure Mechanism of Gob-Side Entry Driven in Thick Coal Seam

Physical Model Study on Brittle Failure of Pressurized Deep Tunnel with Support System

Mechanical characteristics and stability analysis of an innovative type of steel–concrete composite support in shallow-buried excavation tunnels

Numerical Simulation of New Support Structure for High In-situ Stress Tunnel of Sichuan–Tibet Railway

A 3D Ubiquitous-Multiple-Joint Model and Its Application to the Stability Analysis of TBM Excavated Roadway in Jointed Stratum

TEST ON STRUCTURAL PROPERTY AND APPLICATION OF CONCRETE-FILLED STEEL TUBE SUPPORT OF DEEP MINE AND SOFT ROCK ROADWAY

Long-term deformation and control structure of rheological tunnels based on numerical simulation and on-site monitoring

Experimental Study on Pipe Strength and Field Performance of Pipe Jacking TBM in Deep-Buried Coal Mines

Mechanical performances of shield tunnel segments under asymmetric unloading induced by pit excavation

Study on large deformation mechanism and concrete-filled steel tubular support technology for ventilation shaft roadway