Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Acoustic emission for monitoring the damage progress on concrete-filled stainless-steel tubes (CFSST) under bending test

Flexural behavior of concrete-filled circular steel tubes under high-strain rate impact loading

Uniaxial Concrete Tension Damage Evolution Using Acoustic Emission Monitoring

Damage analysis of axially compressed concrete-filled steel tube stub columns based on acoustic emission

Seismic Behavior of Concrete-Filled Wide Rectangular Steel Tubular (CFWRST) Stub Columns

Low Cyclic Fatigue Performance of Concrete-Filled Steel Tube Columns

Damage analysis of concrete-filled square stainless steel columns based on acoustic emission and Markov chain methods

Damage evaluation and failure mechanism analysis of steel tube confined reinforced-concrete columns by acoustic emission technology

Concrete-filled Steel Tubes with Reinforcing Bars or Angles under Axial Tension

Acoustic Emission Monitoring of Progressive Damage of Reinforced Concrete T-Beams under Four-Point Bending

Application on bending performance of annular concrete-filled steel tube stent

Crack detection and damage evaluation of asymmetrical steel-reinforced concrete frame nodes using acoustic emission technology

Experimental Investigation and Design of Thin- Walled Concrete-Filled Steel Tubes Subject to Bending

Cracking Mechanism of Corroded Reinforced Concrete Column Based on Acoustic Emission Technique

Damage Detection of L-Shaped Concrete Filled Steel Tube (L-CFST) Columns under Cyclic Loading Using Embedded Piezoceramic Transducers

To Monitor Fracture Behaviors in Four-Point Cyclic Bending Tests of Low-Activated High Alumina Concrete and Standard Concrete RC Beams Using Acoustic Emission Technique

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Seismic Performance of Stiffened Concrete-Filled Double Skin Steel Tubes

In-situ measurements of temperature and strain fields of large-diameter concrete-filled steel tube columns and the refined finite element modeling

Performance of Concrete-Filled Stainless Steel Tubes Subjected to Tension: Experimental Investigation