Abstract:To address the challenges posed by large propagation loss and severe multipath delay spread, while aiming to improve communication rates in long-range underwater acoustic (UWA) communication, this paper introduces a novel approach: multi-beam (MB) Orthogonal Frequency Division Multiplexing (OFDM) based on deconvolved conventional beamforming (dCv). The proposed method establishes a signal processing framework for UWA channel receivers, wherein received signals corresponding to each angle beam are isolated and concentrated using the dCv technique. Subsequently, the separated signals from each angle undergo maximal-ratio combining (MRC) channel equalization followed by demodulation. Compared to conventional single-beam (SB) processing methods, the proposed approach capitalizes on multipath diversity gain achieved by combining MB outputs originating from various arrival angles. Moreover, employing dCv processing demonstrates superior performance compared to popularly employed beamforming techniques, especially when dealing with paths arriving from closely aligned angles. Additionally, the array beamforming utilized significantly enhances the signal-to-noise ratio (SNR) of each beam output, mitigating the elevated error rates in channel estimation associated with combining low SNR signals received from individual elements. Simulation results utilizing BELLHOP and experimental data from the South China Sea showcase notably improved bit error rate (BER) performance for the proposed method compared to SB equalization, MB-MRC equalization based on conventional beamforming (CBF), minimum variance distortionless response (MVDR), and worst-case performance optimization (WCPO), as well as standard MRC equalization techniques. The proposed receiver achieves error-free decoding results at a communication distance of 80 km with a data rate of 247 bps.

Measurement of distance and speed between transmitter and receiver using propagation time of underwater acoustic communication signals with orthogonal signal division multiplexing

Orthogonal Frequency-Division Multiplexing Underwater Acoustic Communications with Time Reversal Processing

Experimental Studies of Time-Reversal Underwater Acoustic Communications

Experimental demonstration of time reversal communication in doubly dispersive underwater channels

Adaptive Retransmission Scheme for Underwater Acoustic Nodes Based on Distance Ranging

Underwater Acoustic Communication in a Highly Refractive Environment Using SC–FDE

Field testing of underwater acoustic communication using Doppler-resilient orthogonal signal division multiplexing in coastal area of Suruga Bay

Direct Acoustic Communication Between Underwater and Airborne Nodes

Single carrier FDMA over underwater acoustic channels

Cross-Medium Communication Combining Infrared Optical and Acoustic Waves

Time-varying Doppler Compensation for Orthogonal Frequency Division Multiplexing-Based Underwater Acoustic Communications

Cross Power Spectral Density Based Beamforming for Underwater Acoustic Communications

An Underwater Time Reversal Communication Method Using Symbol-Based Doppler Compensation with a Single Sound Pressure Sensor

High-speed Underwater Acoustic Communication System Based on OAM-OFDM Index Modulation

OFDM-IDMA Communications over Underwater Acoustic Channels

Multi-band OFDM for Underwater Acoustic Communications

A Wideband MIMO Underwater Acoustic Communication Experimental System

High-performance deep-sea long-range underwater acoustic communication: Deconvolved conventional beamforming based approach

An Improved Time Delay Measurement Method for the Long-Distance Underwater Environment

Frequency-detected acoustic ranging solutions in wireless sensor networks: an experimental study

Characterization and modeling of high-speed underwater acoustic communication channels