BiOBrnI1-n solid solutions as versatile photooxidation catalysts for phenolics and endocrine disrupting chemicals

Hongwei Zhang,Joanne Chiew Ling Tee,Stephan Jaenicke,Mohammed A. Gondal,Mohamed A. Dastageer,Chanbasha Basheer,Gaik-Khuan Chuah

DOI: https://doi.org/10.1016/j.cattod.2020.01.009

IF: 5.3

2021-09-01

Catalysis Today

Abstract:A novel family of visible-light-sensitive photocatalysts, bismuth oxyhalide solid solutions (BiOBrnI1-n, n = 0–1), was synthesized by a nonaqueous solvothermal method. The bismuth oxyhalides crystallized in individually separated platelets which aggregated into microspheres, allowing for efficient light capture. By increasing the Br/I ratio, the band gap of BiOBrnI1-n could be tuned from 1.95–2.95 eV. The material with the composition BiOBr0.75I0.25 exhibited the best photoactivity. It catalysed the degradation of p-cresol under visible light at a rate 31-times that of pure BiOBr and 1.7-times that of BiOI. BiOBr0.75I0.25 proved to be a versatile photocatalyst for the degradation of a wide range of substituted alkyl phenols and endocrine disrupting chemicals (EDCs). Total organic carbon in the water was reduced to 10–33 % at > 99 % degradation efficiency. The excellent performance was attributed to a matching bandgap, balance between light absorption and redox potential, and efficient charge separation. Recyclability testing showed that BiOBr0.75I0.25 maintained its high activity even after three cycles of p-cresol photodegradation.

chemistry, physical,engineering, chemical, applied

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to develop an efficient photocatalytic material for the degradation of phenolic compounds and endocrine - disrupting chemicals (EDCs) in water. Specifically, the researchers prepared a series of bismuth oxyhalide solid solutions (BiOBr\(_{n}\)I\(_{1 - n}\)) by the solvothermal method and studied the photocatalytic performance of these materials under visible light. By adjusting the ratio of Br/I, the band gap of these materials can be regulated, thereby optimizing their light - absorption ability and redox potential and achieving effective photocatalytic degradation of various phenolic compounds and endocrine - disrupting chemicals.

The main objectives of the paper are:
1. **Synthesize new photocatalysts**: BiOBr\(_{n}\)I\(_{1 - n}\) solid solutions were synthesized by the non - aqueous solvothermal method, and their structures and morphologies were characterized by means such as X - ray diffraction (XRD), transmission electron microscopy (TEM), and scanning electron microscopy (SEM).
2. **Optimize photocatalytic performance**: The influence of different Br/I ratios on the material band gap was studied, and the optimal photocatalyst composition (BiOBr\(_{0.75}\)I\(_{0.25}\)) was determined through photocatalytic experiments.
3. **Evaluate the scope of application**: The photocatalytic degradation effects of BiOBr\(_{0.75}\)I\(_{0.25}\) on various phenolic compounds and endocrine - disrupting chemicals were tested to verify its potential as a general - purpose photocatalyst.
4. **Explore the mechanism of action**: Through techniques such as photoluminescence (PL) and X - ray photoelectron spectroscopy (XPS), the mechanism of the high - efficiency photocatalytic performance of BiOBr\(_{0.75}\)I\(_{0.25}\), including factors such as charge - separation efficiency and surface properties, was explored.

In summary, this paper aims to develop an efficient and general - purpose photocatalyst for treating organic pollutants in water, especially phenolic compounds and endocrine - disrupting chemicals, in order to solve the problem of environmental water pollution.