Calculation method and evaluation of surrounding rock pressure of vertical shaft

Zhongxi Tian,Yuanwu Sun,Qingshuang Zhao,Boliang Zhang,Wanrong Liu,Xutao Zhang

DOI: https://doi.org/10.1038/s41598-024-58516-7

IF: 4.6

2024-04-03

Scientific Reports

Abstract:The surrounding rock pressure of vertical shafts is one of the basic parameters of shaft lining design. Investigating its calculation methods and applicable scopes has great engineering significance. The paper classifies and compares the calculation methods, discusses the application scopes of various calculation methods, and proposes that the axisymmetric layered method is highly consistent with the field monitoring data for the calculation of surrounding rock pressure of vertical shafts in bedrock sections on the basis of practical engineering examples. On the basis of Terzaghi theory, the calculation formula of surrounding rock pressure of vertical shaft in inclined rock strata with single group joints is derived. The formula can reflect the influence of rock strata dip angle and joints.

multidisciplinary sciences

What problem does this paper attempt to address?

This paper primarily explores the calculation methods of shaft surrounding rock pressure and their applicability assessment, and proposes a formula for calculating the shaft surrounding rock pressure in inclined rock layers with a single set of joints.

Specifically, the paper addresses the following key issues:

1. **Classification and Comparison of Surrounding Rock Pressure Calculation Methods**:
- The paper classifies and compares existing methods for calculating surrounding rock pressure, including methods based on loose medium theory and axisymmetric stratification method.
- It analyzes the application scope of various methods and verifies the accuracy of the axisymmetric stratification method in calculating the surrounding rock pressure of shafts in bedrock sections through actual engineering cases.

2. **Calculation of Shaft Surrounding Rock Pressure in Inclined Rock Layers**:
- Based on Terzaghi's theory, a formula for calculating the shaft surrounding rock pressure in inclined rock layers with a single set of joints is derived.
- This formula can reflect the influence of rock layer dip angle and joints.

3. **Discussion on the Applicability of Calculation Methods**:
- By comparing theoretical calculation results with measured data, the applicability range of different calculation methods is discussed.
- It is pointed out that the surrounding rock pressure calculated based on the loose medium theory is much greater than the measured value and is not suitable for bedrock sections; whereas the calculation results of the axisymmetric stratification method are close to the measured values and are suitable for bedrock sections.

In summary, the main purpose of this paper is to study and optimize the calculation methods of shaft surrounding rock pressure, especially the calculation methods for inclined rock layers, to improve the safety and rationality of shaft lining structure design.