Abstract:The successful operation of fusion reactors requires operating scenarios with good core confinement and acceptable first wall heat loads, that are stable and robust to external perturbations. This poses both physical and technological challenges. One of the technologies addressing these challenges is a complex feedback control system. They support advances in physical understanding and help to ensure stable operating conditions. Operating marginally stable plasmas often leads to off-normal events (such as disruptions) and feedback control can prevent these to some extent. This contribution gives an overview of the main results of the development and operation of the feedback control algorithms on ASDEX Upgrade (AUG). Fueling actuators, using a combination of gas valves and pellet injection, can simultaneously control neutral density of the divertor and the density of the plasma core above the Greenwald limit. Impurity injection is employed to control the position of the X-point radiator, allowing the creation of an ELM-suppressed H-mode with high radiation fraction. Heating actuators are used to control the plasma energy content, which supports advanced tokamak experiments and enables stable I-mode operation, and the electron temperature control, which supports turbulence studies. In control technology, AUG has pioneered the use of virtual actuators, which allow effective use of the limited number of heating actuators, adaptive control policies, and exception handling. Such technologies will also be used in ITER. Advanced nonlinear state observers (RAPTOR, RAPDENS) and codes to evaluate the power deposition properties (RABBIT, TORBEAM) are available for routine use in the AUG feedback controllers. Extensive use of the AUG Discharge Control System (DCS) further enhances the research capabilities of this machine.

Feedback control of the sawtooth behavior in nuclear fusion

Control oriented modeling and simulation of the sawtooth instability in nuclear fusion tokamak plasmas

Data-Driven Modeling and Feedback Tracking Control of the Toroidal Rotation Profile for Advanced Tokamak Scenarios in Diii-D

Design and Simulation of Extremum-Seeking Open-Loop Optimal Control of Current Profile in the DIII-D Tokamak

Extremum-Seeking-Based Receding-Horizon Optimal Control of Plasma Current Profile in the DIII-D Tokamak

Poloidal Magnetic Flux Profile Control in Tokamaks Via Normalized Coprime Factorization Robust Control

Robust control of the poloidal magnetic flux profile in the presence of unmodeled dynamics

Experimental and Simulation Testing of Physics-model-based Safety Factor Profile and Internal Energy Feedback Controllers in DIII-D Advanced Tokamak Scenarios

Simultaneous feedback control of plasma rotation and stored energy on NSTX-U using neoclassical toroidal viscosity and neutral beam injection

Sawtooth Control Experiments on HT-7 and EAST Tokamak

Control System of Neoclassical Tearing Modes in Real Time on HL-2A Tokamak

Physics-model-based Nonlinear Actuator Trajectory Optimization and Safety Factor Profile Feedback Control for Advanced Scenario Development in DIII-D

Feedback Control of Edge Turbulence in A Tokamak

Neutral beam stabilization of sawtooth oscillations in JET

Modelling and experiment to stabilize disruptive tearing modes in the ITER baseline scenario in DIII-D

Simultaneous feedback control of toroidal magnetic field and plasma current on MST using advanced programmable power supplies

Core electron temperature turbulence and transport during sawtooth oscillations in the DIII-D tokamak

Overview of advances in ASDEX Upgrade plasma control to support critical physics research for ITER and beyond

Non-linear simulations of neoclassical tearing mode control by externally driven RF current and heating, with application to ITER

Controlling a new plasma regime

Active Control of Alfvén Eigenmodes in Magnetically Confined Toroidal Plasmas