Multifunctional, low swelling and tough wet tissue adhesive sensor based on in situ reduced graphene oxide and polyphenols

Yiming Chen,Yunxiang Weng,Yishi Cheng,Yan Fang,Qinhui Chen,Xianmou Fan,Haiqing Liu
DOI: https://doi.org/10.1016/j.cej.2024.156596
IF: 15.1
2024-10-16
Chemical Engineering Journal
Abstract:Conductive viscous hydrogel has received much research attention in the field of flexible wearable sensors because of its conductivity, adhesion, softness and biocompatibility. However, the expandability, low tissue adhesion and leakage of conductive components of traditional conductive adhesives limit their practical wet application. Hence, based on the redox and adhesive chemistry of polyphenols (TA), a tough double-layer hydrogel sensor (CAT/HArGO-Ag) with low swelling and wet-tissue adhesion was synthesized in an aqueous environment. The upper layer gel (HArGO-Ag) was polymerized by 2-hydroxyethyl methacrylate (HEMA), acrylic acid (AA) and graphene oxide/silver nanoparticles composite (GO-Ag), and then GO was transformed into reduced graphene oxide (rGO) by oxidation and reduction of TA, and the toughness of HArGO-Ag increased by 60.2 % (from 1.18 ± 0.16 MJ/m 3 to 1.89 ± 0.21 MJ/m 3 ). Subsequently, the prepolymer solution of chitosan/acrylic acid/tannic acid (CS/AA/TA) was cured on the surface of the active ester modified HArGO-Ag-NHS gel to obtain CAT/HArGO-Ag, and its interfacial toughness on wet pigskin reached 317.41 J/m 2 , which could effectively close the femoral artery trauma in rats. Owing to the advantages of the phase separation clusters in HArGO-Ag and the networking of CS, CAT/HArGO-Ag showed low swelling (only 0.11). In addition, the experimental results showed that the CAT/HArGO-Ag composite patch had good antioxidant capacity, antibacterial property and biosafety. Finally, the sensitivity (GF) at 80 ∼ 120 % strain was as high as 125.01, and it could also detect sweat pH based on surface enhanced Raman scattering (SRES). Therefore, multifunctional sensing CAT/HArGO-Ag sensor would be expected to be an ideal material for biological non-invasive monitoring and medical care.
engineering, chemical, environmental
What problem does this paper attempt to address?