Rigorous modeling the pH-dependent solubility of weak acids, weak bases and their salts

Espen Fritschka,Gabriele Sadowski
DOI: https://doi.org/10.1016/j.fluid.2024.114039
IF: 2.745
2024-01-26
Fluid Phase Equilibria
Abstract:The solubility of weak acids and bases strongly depends on the pH. Moreover, at very high or low pH, their salts may crystallize. This is of particular importance for active pharmaceutical ingredients (APIs), which usually have a very small aqueous solubility, and often are weak acids or bases. Thus, their solubility is remarkably influenced by changing pH. So far, solubility of APIs was often described by fitting additional parameters to pH-dependent solubility data. This work aims at completely predicting the pH dependent solubility of weak acids and bases just based on their intrinsic solubility without fitting any additional model parameters. This was achieved via a thermodynamically consistent approach that describes the thermodynamic activities of all components present in the system based on ePC-SAFT. This approach was not only applied to model the dissociation of weak acids and bases, but also to model pH itself. In addition, possible salt formation of the solutes in the presence of pH-changing agents was taken into account. The solubility of these salts was also modeled based on their thermodynamic activities. The modeling approach was validated against existing literature data for various acidic as well as basic APIs.
engineering, chemical,thermodynamics,chemistry, physical
What problem does this paper attempt to address?