Investigating the effect of flue gas temperature and excess air coefficient on the size distribution of condensable particulate matters

Yue Peng,Nan Shi,Tao Wang,Jiawei Wang,Yongsheng Zhang,Wei-Yin Chen,Baharak Sajjadi,Wei-Ping Pan

DOI: https://doi.org/10.1016/j.fuel.2021.120866

IF: 7.4

2021-08-01

Fuel

Abstract:Primary particles emitted from fuel combustion mainly involve filterable particulate matter (FPM) and condensable particulate matter (CPM). Particularly, CPM has emerged as a subject for further emission control. This study investigated the effects of the sampling temperature and excess air coefficient (EAC) on the total mass, chemical speciation, and particle size distribution of CPM by integrating Electrical Low-Pressure Impactor+ (ELPI+) sampling devices with the EPA Method 202 (dry impinger method). The total mass of CPM increased with the sampling temperature and EAC. Specifically, the total concentration of CPM was 10.51–39.93 mg/m3, in which the mass fraction of organic species varied between 8.74 and 49.80%, and the organic components in CPM followed the ranking order of alkanes/alkenes (62.6–78.6%), oxygen-containing volatile organic compounds (OVOCs) (19.7–35.4%), and aromatics (5.6%). Compared with other inorganic species such as HCl and NOX, SO3 had a higher migration tendency from the flue gas to CPM. The particle size distribution suggested that heterogeneous condensation was responsible for the whole size range of particles in CPM, whereas the homogeneous condensation led to the increase of finer particles (smaller than 0.2 µm). Accordingly, adjusting the emission temperature and EAC could help to control the emission of CPM.

energy & fuels,engineering, chemical

What problem does this paper attempt to address?

The paper primarily explores the effects of flue gas temperature and excess air coefficient (EAC) on the total mass, chemical composition, and particle size distribution of condensable particulate matter (CPM). The study analyzes CPM by integrating an Electrical Low Pressure Impactor (ELPI+) sampling device with the U.S. EPA Method 202 (dry impinger method).

Main findings include:
- The total mass of CPM increases with the sampling temperature and excess air coefficient.
- The mass fraction of organic components in CPM varies between 8.74% and 49.80%, with alkanes/alkenes being dominant (62.6%-78.6%), followed by oxygenated volatile organic compounds (OVOCs) (19.7%-35.4%), and aromatics being the least (5.6%).
- Compared to other inorganic components like HCl and NOx, SO3 is more likely to migrate from flue gas to CPM.
- The particle size distribution indicates that heterogeneous condensation plays a significant role in CPM formation across the entire size range, while homogeneous condensation leads to an increase in finer particles (less than 0.2 micrometers).
- Adjusting the emission temperature and excess air coefficient helps control CPM emissions.

These results emphasize the importance of understanding and controlling CPM, especially under ultra-low emission conditions where CPM may become a major contributor to particulate emissions. Additionally, the study proposes an improved CPM sampling method that better characterizes the particle size distribution characteristics of CPM.