Abstract:Antibiotic residue, a kind of biomass, is classified as hazardous waste. However, it is considered a good biomass resource because it contains rich organic matter and bacterial protein with a calorific value equivalent to that of low-rank coal. The hydrothermal method uses high-temperature liquid water as the reaction medium and reactant, which has the characteristics of high energy, fast reaction speed, large material flux, convenient feeding, and high product separation efficiency, especially avoiding the evaporation of high water content of aquatic substances. Although bio-oil obtained from the noncatalytic hydrothermal process has a high calorific value, it exhibits negative characteristics, such as high oxygen and nitrogen and high viscosity, which makes it unsuitable for use as a fuel. Therefore, catalysts are needed to improve the quality of bio-oil. This paper investigates the hydrothermal liquefaction of bacterial residues into bio-oil under a retention time of 30–240 min at 220–300 °C. Results show that the maximum yield of bio-oil is 28.01% at 260 °C for 135 min. Catalyzed by six kinds of catalysts (HCOOH, CH3COOH, K2CO3, Na2CO3, NaOH, and KOH), the highest yield of bio-oil is achieved with Na2CO3 (36.06%) and NaOH (36.31%). The content of hydrocarbons and their derivatives in the produced bio-oil is found to be relatively low at varying amounts of Na2CO3 and NaOH catalysts. The mass fraction of nitrogen-containing compounds in the alkali-catalyzed and acid-catalyzed bio-oil is 41.16%–49.74% and 57.62%–59.32%, respectively, with the best nitrogen removal obtained at a mass dosage of 8%. In particular, the contents of nitrogen compounds in the bio-oil catalyzed by Na2CO3 and NaOH are 29.12% and 35.67%, respectively. The best removal effect of oxygen is achieved at a dosage of 10%. Specifically, bio-oil components produced by Na2CO3 and NaOH contains 32.12% and 29.02% oxygen-containing compounds, respectively. Moreover, the higher heating value (HHV) of bio-oil produced with these catalysts is the largest, with an HHV of 33.3220 and 34.7320 MJ·kg−1 for Na2CO3 and NaOH, respectively.

Preparation of bio-oils by hydrothermal liquefaction (HTL) of penicillin fermentation residue (PR): Optimization of conditions and mechanistic studies

Catalytic Hydrothermal Liquefaction of Penicillin Residue for the Production of Bio-Oil over Different Homogeneous/Heterogeneous Catalysts

Effects of aqueous phase circulation and catalysts on hydrothermal liquefaction (HTL) of penicillin residue (PR): Characteristics of the aqueous phase, solid residue and bio oil

Study on hydrothermal liquefaction of antibiotic residues for bio-oil in ethanol-water system

Characteristic Analysis of Bio-oil from Penicillin Fermentation Residue by Catalytic Pyrolysis

Thermal characteristics and product formation mechanism during pyrolysis of penicillin fermentation residue.

Study on the hydrothermal liquefaction of antibiotic residues with molecular sieve catalysts in the ethanol–water system: focus on product distribution and characterization

Migration and Transformation of Nitrogen During Hydrothermal Liquefaction of Penicillin Sludge

Catalytic upgrading of penicillin fermentation residue bio-oil by metal-supported HZSM-5

Effct of Thermo-Alkaline Pretreatment on Anarobic Fermentation of Penicillin Mycelium Residues

Preparation and Properties of Bio-Oil from the Antibiotic Residue by Hydrothermal Liquefaction

Study on the nitrogen migration mechanism during penicillin fermentation residue fast pyrolysis based on the substance transformation and canonical variational theory

Effect of Fe, Ni, and Co on the hydrothermal liquefaction of Chinese herb residue for bio-oil production

Enhanced biogas production from penicillin bacterial residue by thermal-alkaline pretreatment

Influence of temperature, residence time, and solvent/feedstock mass ratio on overall product distribution and oil products quality in ethanol liquefaction of 230 polypropylene impact copolymer

Hydrothermal Liquefaction of Cd-enriched Amaranthus Hypochondriacus L. in Ethanol–water Co-Solvent: Focus on Low-N Bio-Oil and Heavy Metal/metal-Like Distribution

In-depth Study of Synergism Between Torrefaction and Catalyst for Balanced Production of Bio-Oil from Rice Husk Pyrolysis Based on Hydrocarbons Production, Energy Yield and Deoxygenation Degree

Optimisation of a catalytic hydrothermal liquefaction process using central composite design for yield improvement of bio-oil

Optimizing invasive plant biomass valorization: Deep eutectic solvents pre-treatment coupled with ZSM-5 catalyzed fast pyrolysis for superior bio-oil quality

Bio-oil from fast pyrolysis of lignin: Effects of process and upgrading parameters

Study of bio-oil production from sewage sludge of a municipal wastewater treatment plant by using hydrothermal liquefaction (HTL)