Abstract:It was experimentally found that silica and gold particles can modify the combustion properties of nanothermites but the exact role of the thermal properties of these additives on the propagating combustion front relative to other potential contributions remains unknown. Gold and silica particles of different sizes and volume loadings were added into aluminum/copper oxide thermites. Their effects on the flame front dynamics were investigated experimentally using microscopic dynamic imaging techniques and theoretically via a reaction model coupling mass and heat diffusion processes. A detailed theoretical analysis of the local temperature and thermal gradients at the vicinity of these two additives shows that highly conductive inclusions do not accelerate the combustion front while poor conductive inclusions result in the distortion of the flame front (corrugation), and therefore produce high thermal gradients (up to 1010K.m-1) at the inclusion/host material interface. This results in an overall slowing down of the combustion front. These theoretical findings contradict the experimental observations in which a net increase of the flame front velocity was found when Au and SiO2particles are added into the thermite. This leads to the conclusion that the faster burn rate observed experimentally cannot be fully associated with thermal effects only, but rather on chemical (catalytic) and/or mechanical mechanisms: formation of highly-stressed zones around the inclusion promoting the reactant mixing. One additional experiment in which physical SiO2particles were replaced by voids (filled with Ar during experiment) to cancel the potential mechanical effects while preserving the thermal inhomogeneity in the thermite structure confirms the hypothesis that instead of pure thermal conduction, it is the mechanical mechanisms that dominate the propagation velocity in our specific Al/CuO multilayered films.

Microwave antenna focusing for spatially resolved modulation of burn rate

Ion Write Microthermotics: Programing Thermal Metamaterials at the Microscale

Microwave Stimulation of Energetic Al-Based Nanoparticle Composites for Ignition Modulation

Microwave Ignition Characteristics and Distinction of Typical Nanothermites under Different Electromagnetic Radiation

A Smart Thermite with Tunable Properties – Doping of Al/Cuo with Microwave Absorbing Ti3c2 Mxene for Improved Ignition and Combustion Performance

Nanoscale thermal gradients activated by antenna-enhanced molecular absorption in the mid-infrared

Nanoscale Control of Temperature Distribution Using a Plasmonic Trimer

Microwave Ignition of Thermites

Microwave heating of carbon materials for on-demand thermal patterning via tunable electromagnetic resonators

High speed 2-dimensional temperature measurements of nanothermite composites: Probing thermal vs. Gas generation effects

Multi-criterion optimization of invasive antenna applicators for Au@Fe3O4, Au@-Fe2O3 and Au@-Fe2O3 mediated microwave ablation treatment

Imaging Local Heating and Thermal Diffusion of Nanomaterials with Plasmonic Thermal Microscopy

Elucidating the dominant mechanisms in burn rate increase of thermite nanolaminates incorporating nanoparticle inclusions

Temperature Detection Based on Surface Plasmon Resonance Sensor for Microwave Ablation

Microwave Hyperthermia Technology Based on Near‐Field Focused Metasurfaces: Design and Implementation

Quo Vadis, Nanothermite? A Review of Recent Progress

Expanded modeling of temperature-dependent dielectric properties for microwave thermal ablation

Thermal field study of ceramic slot microwave ablation antenna based on specific absorption rate distribution function

Pushing the Limits of Energy Performance in Micron-Sized Thermite: Core–Shell Assembled Liquid Metal-Modified Al@Fe2O3 Thermites

3D ordered macroporous NiO/Al nanothermite film with significantly improved higher heat output, lower ignition temperature and less gas production

Highly Efficient Microwave Heating for Target Area Based on Metamaterial