Abstract:Perfluorooctanoic acid (PFOA), a typical perfluorinated carboxylic acid, is an emerging type of permanent organic pollutants that are regulated by the Stockholm Convention. The degradation of PFOA, however, is quite challenging largely due to the ultra-high stability of C-F bonds. Compared with other techniques, photocatalytic degradation offers the potential advantages of simple operation under mild conditions as well as exceptional decomposition and defluorination efficiency. Titanium dioxide (TiO 2 ) is one of the most frequently used photocatalysts, but so far, the pristine nanosized TiO 2 (e.g., the commercial P25) has been considered inefficient for PFOA degradation, since the photo-generated hydroxyl radicals from TiO 2 are not able to directly attack C-F bonds. Mesoporous Sb 2 O 3 /TiO 2 heterojunctions were therefore rationally designed in this work, of which the confined Sb 2 O 3 nanoparticles in mesoporous TiO 2 framework could not only tune the band structure and also increase the number of active sites for PFOA degradation. It was found that, after loading Sb 2 O 3 , the absorption of UV light was enhanced, indicating a higher efficiency of light utilization; while the band gap was reduced, which accelerated the separation of photo-generated charge carriers; and most importantly, the valence band edge of the Sb 2 O 3 /TiO 2 heterojunction was significantly lifted so as to prevent the occurrence of hydroxyl radical pathway. Under the optimal ratio of Sb 2 O 3 –TiO 2 , the resulting catalysts managed to remove 81.7% PFOA in 2 h, with a degradation kinetics 4.2 times faster than the commercial P25. Scavenger tests and electron spin resonance spectra further revealed that such improvement was mainly attributed to the formation of superoxide radicals and photo-generated holes, in which the former drove the decarboxylation from C 7 F 15 COOH–C 7 F 15 • , and the latter promoted the direct electron transfer for the conversion of C 7 F 15 COO − –C 7 F 15 COO • . The Sb 2 O 3 /TiO 2 photocatalysts were highly recyclable, with nearly 90% of the initial activity being retained after five consecutive cycles, guaranteeing the feasibility of long-term operation.

Enhanced electrochemical oxidation of perfluorooctanoic acid on Ti/SnO 2 -Sb electrode by surface morphology regulation

Efficient Electrochemical Oxidation of Perfluorooctanoate Using a Ti/SnO2-Sb-Bi Anode

Highly Efficient Electrochemical Degradation of Perfluorooctanoic Acid (PFOA) by F-doped Ti/SnO2 Electrode.

Base-metal Oxide Semiconductor Electrodes for PPCP Degradation: Ti-doped Α-Fe2o3 for Sulfosalicylic Acid Oxidation As an Example.

Electrochemical mineralization of perfluorooctane sulfonate by novel F and Sb co-doped Ti/SnO2electrode containing Sn-Sb interlayer

Enhanced perfluorooctane acid mineralization by electrochemical oxidation using Ti3+ self-doping TiO2 nanotube arrays anode

Electrochemical Oxidation of Environmentally Persistent Perfluorooctane Sulfonate by A Novel Lead Dioxide Anode

Decomposition of perfluorooctanoic acid from wastewater using coating electrode: efficiency, the anode characteristics and degradation mechanism

A facile electroless preparation of Cu, Sn and Sb oxides coated Ti electrode for electrocatalytic degradation of organic pollutants

Electrochemical Oxidation of Perfluorooctanoic Acid (PFOA) from Aqueous Solution using Non-Active Ti/SnO2-Sb2O5/PbO2 Anodes

Degradation of a Persistent Organic Pollutant Perfluorooctane Sulphonate with Ti/SnO2–Sb2O5/PbO2-PTFE Anode

Amorphous Pd-Loaded Ti4o7 Electrode For Direct Anodic Destruction Of Perfluorooctanoic Acid

Electrochemical degradation of perfluorooctanoic acid (PFOA) by Ti/SnO2-Sb, Ti/SnO2-Sb/PbO2 and Ti/SnO2-Sb/MnO2 anodes

Photochemical Anti-Fouling Approach for Electrochemical Pollutant Degradation on Facet-Tailored TiO2 Single Crystals.

Electrochemical oxidation of PFOA in aqueous solution using highly hydrophobic modified PbO2 electrodes

Enhanced Photocatalytic Degradation of Perfluorooctanoic Acid by Mesoporous Sb2O3/TiO2 Heterojunctions

[Selection of Electrochemical Anodic Materials for PFOA Degradation and Its Mechanism].

Performance enhancement and mechanism of electroenhanced peroxymonosulfate activation by single-atom Fe catalyst modified electrodes

Enhanced decomposition of long-chain perfluorocarboxylic acids (C9−C10) by electrochemical activation of peroxymonosulfate in aqueous solution

Enhanced performance of an Al-doped SnO2 anode for the electrocatalytic oxidation of organic pollutants in water