Abstract:All-carbon flexible supercapacitors are highly promising in powering up wearable electronics in smart textiles. However, their low energy density hinders their practical application due to the lack of an effective fabrication method of highly conductive fiber electrodes with high specific capacitance. Herein, we develop a sustainable, scalable, and cost-effective method to fabricate lignin-based carbon/graphene fiber (GF) hybrid electrodes with a hierarchically porous structure. This engineered structure is achieved by coaxially wet spinning a graphene oxide fiber (GOF) as a core structural support and 0–10% lignin/graphene oxide (GO) as a surface layer, followed by carbonization and KOH activation processes. The obtained fiber electrodes exhibit the highest specific capacitance of 260.48 mF cm–2 at a current density of 0.1 mA cm–2, which is 11 times that of the neat GF from conventional wet spinning. The entire-device energy density of the assembled fiber-based flexible supercapacitors from the optimal fiber electrode is 5.79 μW h cm–2 in a H2SO4/poly(vinyl alcohol) electrolyte. Furthermore, the fiber-based flexible supercapacitors show ultralong cycling life and cycling stability (the capacitance retention rate is 98% after 7000 cycles of charge/discharge at a current density of 0.1 mA cm–2). This work enables the high-value utilization of low-cost carbon precursors (lignin and GO) in potential applications such as energy storage devices for smart textiles.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01379.Polarized optical microscopy image of GO solution at 15 mg mL–1; SEM images of the neat GF and unactivated 5% ; FTIR images of the GOF and GF; CV and GCD curves of the GF, unactivated 5% recorded at 5 mV s–1 and 0.1 mA cm–2; CV and GCD curves of flexible supercapacitors tested in a 2-electrode cell in 1 M H2SO4/PVA electrolyte of 0–10% ; electrical conductivity of ; calculated CA, CV, Esingle,A, and Psingle,A values of fiber electrodes based on GCD curves at a current density of 0.1 mA cm–2; calculated CA of fiber electrodes at different scan rates based on CV measurements; and calculated CA of fiber electrodes at current densities based on GCD measurements (PDF)This article has not yet been cited by other publications.

Carbonized wood cell chamber-reduced graphene oxide@PVA flexible conductive material for supercapacitor, strain sensing and moisture-electric generation applications

Covalent modified reduced graphene oxide: Facile fabrication and high rate supercapacitor performances

Cellulose nanofiber-based hybrid hydrogel electrode with superhydrophilicity enabling flexible high energy density supercapacitor and multifunctional sensors

Non-carbonized porous lignin-free wood as an effective scaffold to fabricate lignin-free Wood@Polyaniline supercapacitor material for renewable energy storage application

Chitosan-based oxygen-doped activated carbon/graphene composite for flexible supercapacitors

High-mass loaded redox-active lignin functionalized carbonized wood collector to construct sustainable and high-performance supercapacitors

Free-standing Reduced Graphene Oxide/MoO3-x Composite Film with High Performance for Flexible Supercapacitors

Wood-derived carbon electrodes prepared via simple surface treatment for high performance supercapacitors

Hydrothermal regulation of MnO2 on a wood-based RGO composite for achieving wide voltage windows and high energy density supercapacitors

Co/CoS nanofibers with flower-like structure immobilized in carbonated porous wood as bifunctional material for high-performance supercapacitors and catalysts

Flexible Supercapacitor Electrode with High Performance Prepared from Graphene Oxide Films Assembled in the Presence of P -Phenylenediamine and Urea

Construction of a porous carbon skeleton in wood tracheids to enhance charge storage for high-performance supercapacitors

Chitosan modified graphene oxide with MnO 2 deposition for high energy density flexible supercapacitors

Chitosan/graphene oxide hybrid hydrogel electrode with porous network boosting ultrahigh energy density flexible supercapacitor

High performance flexible supercapacitors based on porous wood carbon slices derived from Chinese fir wood scraps

Flexible Conductive Cellulose Network-Based Composite Hydrogel for Multifunctional Supercapacitors

Energy storage of supercapacitor electrodes on carbon cloth enhanced by graphene oxide aerogel reducing conditions

Electrochemical Performance of Coaxially Wet-Spun Hierarchically Porous Lignin-Based Carbon/Graphene Fiber Electrodes for Flexible Supercapacitors

In-situ synthesis of flexible nanocellulose/carbon nanotube/polypyrrole hydrogels for high-performance solid-state supercapacitors

Combining Nature‐Inspired, Graphene‐Wrapped Flexible Electrodes with Nanocomposite Polymer Electrolyte for Asymmetric Capacitive Energy Storage

Reduced Graphene Oxide Hydrogel for High Energy Density Symmetric Supercapacitor with High Operation Potential in Aqueous Electrolyte