Peroxymonosulfate activation by low-cost modified rubber during contact electrification for antibiotics efficient degradation at circumneutral pH: Mechanism and toxicity assessment

Chao Liu,Lifang Zhao,Jiaxuan Li,Jingxue Wang,Hongwei Xu,Xiaxia Chen,Jianguang Qi,Chaoyue Sun,Zhaoyou Zhu,Yinglong Wang,Fanqing Meng

DOI: https://doi.org/10.1016/j.ces.2023.119642

IF: 4.7

2023-12-22

Chemical Engineering Science

Abstract:Contact electrification is known as a traditional phenomenon widely used in the green energy field, but its application in water pollution control is rarely reported. Herein, a new strategy to activate peroxymonosulfate (PMS) by contact-electro-catalysis (CEC) for antibiotics degradation was proposed and a series of contact-electro-catalysts was prepared by modified low-cost ethylene-propylene-diene-monomer rubber (EPDM). In CEC system, the optimized contact-electro-catalysts (S-EPDM/Fe-5) could degrade 91.38 % of 10 ppm TC within 30 min at a PMS dosage of 0.5 mM and pH of 6.9. 1 O 2 and SO 4 − radicals were demonstrated as main active substances for tetracycline degradation. Based on HPLC-MS results and DFT calculation, tetracycline degradation path in CEC system was proposed. The toxicity evaluation results showed that acute toxicity and bioaccumulation factor of intermediates during tetracycline degradation were significantly reduced. This work provides a new strategy and low-cost catalysts for PMS activation to promote its application in water treatment.

engineering, chemical