Abstract:Lithium oxygen(Li-O 2 ) batteries have been recognized as one of the next-generation power sources, capable of supplying power for a long time even in an independent extreme environment. In spite of the theoretical advantage, Li-O 2 batteries face technical and economical challenges that must be addressed to promote them as commercially variable techcologies for future energy system. Above all, battery performance largely depends on the activities of the cathode during discharge and charge, respectively. The undesirable overpotential caused by sluggish reaction kinetics assiciated with the ORR and OER greatly limit the current performance of Li-O 2 batteries, which must be improved by efficient catalyzing the reactions. Among the numerous catalysts, perovskite oxides have attention for candidate electrocatalyst for Li-O 2 batteries due to their high electronic/ionic conductivity, high electrochemical stability, and catalytic activity. Especially, La 0.6 Sr 0.4 Co 0.2 Fe 0.8 O 3 (LSCF) is considered as a typical catalyst for Li-O 2 batteries, which and provide high oxygen surface exchange coefficient for fast kinetics at the gas/electrode interface. The surface area is significantly related on the ORR and OER performance, which influences on the active area for reactions. In this study, we have tried to utilize a simple high energy ball milling process to investigate the electrochemical properties of LSCF catalyst. Through the BET analysis, it was confirmed that the specific area significantly was increased after ball milling due to the reduced particle size, obtaining the optimized milling time with the higher ORR performance. The electrochemical activities have been measured with rotating disk electrode(RRDE) method. Well-ball milled LSCF catalyst has resulted in the enlargement of specific surface area and increased defective sites, which improve the catalytic activity. To investigate the influence of LSCF oxides on the ORR process, the performance of composite electrode with LSCF catalyst in LITFSI in either solvents has been compared with a carbon based cathode(carbon nano tube(CM130)). From the discharge results, the composite electrode showed the superior performance as well as higher specific capacitance (more than 1.6 times) than carbon based electrode dye to the altered transport and reaction kinetics due to LSCF. In this study, we have proposed the processes of obtaining a catalyst with optimal electrochemical properties through a relatively simple process and applied it to electrode for lithium oxygen batteries.

Oxygen reduction reaction induced electrode effects in polymer light-emitting electrochemical cells

Impact of the electrode material on the performance of light-emitting electrochemical cells

Electrical current modeling for polymer light-emitting electrochemical cells: Contributions from electrons, ions, and oxygen

Chemical doping to control the in-situ formed doping structure in light-emitting electrochemical cells

Efficient Charge Carrier Injection And Balance Achieved By Low Electrochemical Doping In Solution-Processed Polymer Light-Emitting Diodes

Engineering Phosphorus-Doped LaFeO3-δ Perovskite Oxide As Robust Bifunctional Oxygen Electrocatalysts in Alkaline Solutions

Polymer Electret Improves the Performance of the Oxygen-Doped Organic Field-Effect Transistors

Influence of reaction cell electrodes on organic electrochemical transistors

N-Type Doping in Organic Electronic Devices

Effect of low-dose doping of small-molecules on the surface potential and carrier balance of TADF OLEDs

Conductive Polymer Coated Cathodes in Li–O2 Batteries

Recent Progress on Transition Metal Based Layered Double Hydroxides Tailored for Oxygen Electrode Reactions

Electron Accumulation Induced by Electron Injection‐Incomplete Discharge on NiFe LDH for Enhanced Oxygen Evolution Reaction

Effect of N-doping-derived Solvent Adsorption on Electrochemical Double Layer Structure and Performance of Porous Carbon

Promoting Oxygen Electrode Reaction Kinetics in Photo-Assisted Li-O2 Batteries Through Heterostructure Design and Built-In Electric Field Construction

Electrochemical in Situ Na Doping to Construct High-Performance Lithium-Rich Cathode

Investigating the Effect of the Conductivity of the Electron Transportation Layer on the Organic Light-Emitting Diodes

Effect of Pd doping on the activity and stability of directly assembled La0.95Co0.19Fe0.76Pd0.05O3-δ cathodes of solid oxide fuel cells

Extremely Large Polymer Light‐Emitting Electrochemical Cells with Concentric Circular Electrodes

A Mechanistic Insight into the Oxygen Redox of Li‐Rich Layered Cathodes and their Related Electronic/Atomic Behaviors Upon Cycling

Study on the Effect of Surface Area on the ORR Performance of Perovskite Catalyst for High Performance Lithium-Oxygen Batteries