Abstract:Growth of the single-fluid single-mode Rayleigh-Taylor instability (RTI) is revisited in 2D and 3D using fully compressible high-resolution simulations. We conduct a systematic analysis of the effects of perturbation Reynolds number ($Re_p$) and Atwood number ($A$) on RTI's late-time growth. Contrary to the common belief that single-mode RTI reaches a terminal bubble velocity, we show that the bubble re-accelerates when $Re_p$ is sufficiently large, consistent with [Ramaparabhu et al. 2006, Wei and Livescu 2012]. However, unlike in [Ramaparabhu et al. 2006], we find that for a sufficiently high $Re_p$, the bubble's late-time acceleration is persistent and does not vanish. Analysis of vorticity dynamics shows a clear correlation between vortices inside the bubble and re-acceleration. Due to symmetry around the bubble and spike (vertical) axes, the self-propagation velocity of vortices points in the vertical direction. If viscosity is sufficiently small, the vortices persist long enough to enter the bubble tip and accelerate the bubble [Wei and Livescu 2012]. A similar effect has also been observed in ablative RTI [Betti and Sanz 2006]. As the spike growth increases relative to that of the bubble at higher $A$, vorticity production shifts downward, away from the centerline and toward the spike tip. We modify the Betti-Sanz model for bubble velocity by introducing a vorticity efficiency factor $\eta=0.45$ to accurately account for re-acceleration caused by vorticity in the bubble tip. It had been previously suggested that vorticity generation and the associated bubble re-acceleration are suppressed at high $A$. However, we present evidence that if the large $Re_p$ limit is taken first, bubble re-acceleration is still possible. Our results also show that re-acceleration is much easier to occur in 3D than 2D, requiring smaller $Re_p$ thresholds.

Numerical study of three-dimensional single-mode Rayleigh-Taylor instability in turbulent mixing stage

Late-time Description of Immiscible Rayleigh-Taylor Instability: A Lattice Boltzmann Study

Numerical investigations of Rayleigh–Taylor instability with a density gradient layer

Experimental investigation of three-dimensional Rayleigh–Taylor instability of a gaseous interface

On the miscible Rayleigh-Taylor instability: two and three dimensions

Modeling and Simulation of a Single-Mode Multiphase Richtmyer–Meshkov Instability with a Large Stokes Number

Revisiting the Late-Time Growth of Single-mode Rayleigh-Taylor Instability and the Role of Vorticity

Discrete Boltzmann modeling of Rayleigh-Taylor instability: effects of interfacial tension, viscosity and heat conductivity

Rayleigh-Taylor instability under multi-mode perturbation: discrete Boltzmann modeling with tracers

Numerical Simulation of the Rayleigh-Taylor Instability Using the MPS Method

Kinetics of Rayleigh-Taylor instability in van der Waals fluid: the influence of compressibility

Delineation of the flow and mixing induced by Rayleigh-Taylor instability through tracers

Specific heat ratio effects of compressible Rayleigh-Taylor instability studied by discrete Boltzmann method

Analytical Model of Nonlinear Evolution of Single-Mode Rayleigh–Taylor Instability in Cylindrical Geometry

Surface tension effects on Rayleigh-Taylor instability in nonideal fluids: A multiple-relaxation-time discrete Boltzmann study

Weakly Nonlinear Incompressible Rayleigh–Taylor–Kelvin–Helmholtz Instability in Plane Geometry

Viscous Rayleigh-Taylor Instability with and Without Diffusion Effect

Effects of Viscosity and Elasticity on Rayleigh–Taylor Instability in a Cylindrical Geometry

Bubble Re-Acceleration Behaviours in Compressible Rayleigh–Taylor Instability with Isothermal Stratification

Numerical Study of Rayleigh-Taylor Instability by Using Smoothed Particle Hydrodynamics

Rayleigh-Taylor instability in binary fluids with miscibility gap