A Digital Twin Platform Integrating Process Parameter Simulation Solution for Intelligent Manufacturing

Haoran Wang,Zuoqing Yang,Quan Zhang,Qilei Sun,Enggee Lim

DOI: https://doi.org/10.3390/electronics13040802

IF: 2.9

2024-02-20

Electronics

Abstract:The present work aims to develop a digital twin system typical of intelligent manufacturing applications, which has integrated visualization technologies, as well as the process parameter simulation solution. The application under consideration is a typical machining process, with a gantry machine tool controlled by Siemens Programmable Logic Controller(PLC) S7-1200. With the establishment of dual-directional data communication between the physical machine tool and its virtual counterpart based on TCP/IP protocol, real-time visualization, monitoring, and control of the entire working process can be achieved. Furthermore, we integrated with the digital twin system as a solution for real-time process parameter simulation based on finite element modeling (FEM), which enables the real-time monitoring of necessary process parameters, e.g., surface deformation, during the machining process. A preliminary experiment was conducted to validate our proposed digital twin system, and the results demonstrated that our proposed method has satisfactory performance in terms of both control and monitoring of the traditional machining process, and synchronization between the physical and virtual models is also proven to be positive with minimal latency.

engineering, electrical & electronic,computer science, information systems,physics, applied

What problem does this paper attempt to address?

Based on the provided text content, the main problem that this paper attempts to solve is as follows:

In intelligent manufacturing applications, although the existing digital twin technology can achieve real - time monitoring of the processing equipment itself, such as the posture and motion monitoring of the equipment, it has not yet been able to achieve comprehensive real - time monitoring of key process parameters during the processing, especially the real - time state monitoring of the processed object. For example, when performing the basic extrusion process, it is impossible to monitor the deformation of the object under the current load in real - time. This limitation hinders industrial facilities from achieving synchronous real - time monitoring of processing equipment and its targets, and further affects the ability to construct a complete digital twin model of the processing process.

To this end, the paper proposes a digital twin platform integrating process parameter simulation solutions, aiming to solve the above problems in the following ways:
- Establish two - way data communication between the physical machine tool and the virtual model, and based on the TCP/IP protocol, realize real - time visualization, monitoring and control of the entire working process.
- Integrate the finite element modeling (FEM) technology to realize real - time process parameter simulation, especially being able to realize real - time monitoring of necessary process parameters during the processing, such as surface deformation.
- Verify the performance of the proposed digital twin system through preliminary experiments. The results show that this method exhibits satisfactory performance in controlling and monitoring traditional processing processes, and the synchronization between the physical and virtual models has the characteristic of low latency.

In general, this research aims to improve the decision - making efficiency and process optimization ability of the manufacturing process by developing a digital twin system capable of real - time monitoring and optimizing the processing process, thereby promoting the development of intelligent manufacturing.