Abstract:In tunnel fires, smoke is the main fatal factor causing casualties. The technical parameters of tunnel smoke extraction are particularly critical. However, the parameters related to smoke control have rarely been experimentally and quantitatively studied in a tunnel caused by two adjacent fire sources. Numerical simulations were performed to study the plug-holing phenomenon in the centralized smoke exhaust tunnel with multi-fire sources. A 1:10 small-scale tunnel (length 25 m; width 1.2 m; height 0.8 m) was built using FDS. The effects of different fire heat release rates Q̇ , fire source separation distances, and smoke exhaust velocities ( v ) on the plug-holing were considered. Firstly, the smoke layer height beneath the exhaust vent gradually increases as the exhaust velocity becomes higher and then remains almost unchanged until the plug-holing phenomenon occurs. Additionally, the smoke layer height becomes lower as the fire source separation distance increases for the fires with constant heat release rate. For all Q̇ values, the critical plug-holing velocity increases with the increasing separation distance S and Q̇ . In addition, by modifying the critical Froude number ( Fr c ), a predictive model of the critical plug-holing velocity considering the dimensionless fire source heat release rate and separation distance is obtained. Furthermore, the modified critical Froude number model, accounting for two adjacent fires with different separation distances, is established. The correlation between the new model and the simulation results shows quite good agreement, indicating that the proposed model can provide a satisfactory prediction for the critical smoke exhaust velocity in plug-holing conditions of double fire sources. This work can provide valuable guidance for tunnel design concerning fire safety.

Study on critical length for simulation in tunnel fires

Study On Temperature Decay Characteristics Of Fire Smoke Backflow Layer In Tunnels With Wide-Shallow Cross-Section

Experimental Study of Back-Layering Length and Critical Velocity in Longitudinally Ventilated Tunnel Fire with Various Rectangular Cross-Sections

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

Study on the effect of tunnel dimensions on the smoke layer thickness in naturally ventilated short tunnel fires

Study of critical velocity and back-layering length with fire sources both inside and outside a tunnel

Full-scale tests on smoke temperature distribution in long-large subway tunnels with longitudinal mechanical ventilation

Critical Longitudinal Ventilation Velocity for Smoke Control in a Tunnel Induced by Two Nearby Fires of Various Distances: Experiments and a Revisited Model

Numerical study on plug-holing of double fires in tunnel with centralized smoke exhaust

Numerical Investigation on the Influence of Length–Width Ratio of Fire Source on the Smoke Movement and Temperature Distribution in Tunnel Fires

Experimental study on the characteristics of fire smoke longitudinal crossflow in adjacent tunnels

On the Maximum Smoke Temperature under the Ceiling in Tunnel Fires

Numerical and experimental study on the critical velocity and smoke maximum temperature in the connected area of branch tunnel

Numerical Study on Smoke Temperature Characteristics in T-shaped Bifurcated Tunnel Fires

Study on the Length of Smoke Backlayering of Double-Source Fire in Tunnels

Numerical study on thermally driven smoke flow characteristics in long tunnels under natural ventilation

Smoke movement and control in longitudinal ventilated tunnel fires with cross-passages

Numerical study on temperature distribution of tunnel structure in fires

Experimental and Numerical Study of Smoke Temperature Distribution Characteristics in a Sloped Tunnel

Theoretical and numerical study on smoke descent during tunnel fires under natural ventilation condition

Numerical Study on the Critical Criterion for Predicting the Plug-Holing under Lateral Mechanical Exhaust in Tunnel Fires: Considering the Effect of Smoke Flow in Longitudinal Direction