Geometry-Optimized Flexible Ferroelectret Fabricated by Laser Patterning of an Adhesive Spacer

Hao Yang,Rui M. R. Pinto,Pedro González-Losada,Mohammadmahdi Faraji,Rosana Dias,K. B. Vinayakumar

DOI: https://doi.org/10.1109/jsen.2024.3368701

IF: 4.3

2024-01-01

IEEE Sensors Journal

Abstract:The growing demand for continuous cardiac signal monitoring has propelled the development of highly sensitive flexible sensors with reduced power requirements. Proposed flexible ferroelectrets/piezoelectrets are voided polymers that can be polarized/poled, acquiring a piezoelectric behavior that is suited for sensing applications. Here, ferroelectret preparation was achieved by laser-patterning of an adhesive-coated polypropylene (PP) spacer with low Young’s modulus, resulting in improved piezoelectric coefficient while avoiding high-temperature thermal bonding between the different ferroelectret layers. The spacer pattern and thickness were optimized and compared to a suitable analytical model. The optimized piezoelectret showed a low compressive modulus (~300 kPa), a maximum dynamic piezoelectric coefficient d33 = 81 ± 5 pC/N and a quasi-static piezoelectric coefficient of ~8552 pC/N. In the short term, the sensors were stable in a wide range of temperature and relative humidity, but after 70 days at room temperature the d33 decreased to ~36 % of the initial value. Finally, the optimized ferroelectret device was demonstrated in the measurement of the human pulse and extraction of cardiovascular parameters (heart rate and carotid-femoral pulse wave velocity).

engineering, electrical & electronic,instruments & instrumentation,physics, applied