Thermal performance assessment of alumina/graphene oxide hybrid nanofluid in annular passage of multiple configurations

Abdelrazek, Ali H.,Mat Ali, Mohamed Sukri

DOI: https://doi.org/10.1007/s10973-023-12821-x

IF: 4.755

2024-02-06

Journal of Thermal Analysis and Calorimetry

Abstract:The current study investigated the effect of both the intrinsic and extrinsic parameters of annular flow on the thermal performance of alumina/graphene oxide (Al 2 O 3 /GO) for fully developed turbulent flow by A 3-D CFD model. A fully circular annular pipe (the cross-section is a full circle for both the outer pipe and inner rod) and an annular pipe with a diamond-shaped inner rod were considered in the study. An aqua-based hybrid nanofluid containing Al 2 O 3 : GO nanocomposite of 80%: 20% mass mixing ratio, respectively, was tested in comparison with the distilled water (DW) as a heat transfer fluid in both annular passages. The hybrid nanofluid of volumetric concentrations 0.1%, 0.3%, 0.5%, and 0.75% was selected from a published work, and its density and specific heat were calculated theoretically by the current research. The effect of heating location on thermal performance was investigated by alternating a uniform heat flux boundary at the inner rod and outer pipe. The CFD model was verified experimentally using a DW run experiment with a fully circular annular pipe with inner heating under a Reynolds number range between 3000 and 8500. The results generally concluded that the annular pipe with a diamond-shaped inner rod has a higher shape performance index than the fully circular annular pipe, and the inner heating has a higher heat transfer coefficient than that of the outer heating for all nanofluid concentrations in both pipe configurations.

chemistry, physical, analytical,thermodynamics