Abstract:Composite biomaterials were created by sintering soda-lime-silica glass powder and tetracalcium phosphate powder. Sintering of the samples at 1200 °C/2h led to the formation of wollastonite, calcium phosphate, and cristobalite before soaking in simulated body fluid (SBF). However, after soaking for two weeks in SBF the hydroxyapatite, wollastonite, and cristobalite phases appeared with relatively intense in hydroxyapatite phase on sample surfaces. The microstructure shows micro-scale particles on the sample surface after soaking in SBF. The bulk densities and porosities were within 1.82453–1.9672 g/cm3 and 15.0621–34.1657 % respectively whereas compressive strength values were between 42.79 and 111.26 MPa. Since the increase of the porosity in the direction of high addition of phosphate portion while strengths were high in opposite values. The biocompatibility in SBF increases with increasing the SLS glass portion and the SEM micrographs show fine spherical crystals, within 20–200 nm, of hydroxyapatite phase on composite surfaces. The FTIR spectrum after soaking in SBF indicates the presence of phosphate bands in all samples and the intensity of these bands increases as the SLS glass percentage increases. The degradation of composite samples decreases in the direction of an increase in the phosphate portion which led to a decrease in the porosity and an increase in both density and strength. Pseudomonas aeruginosa and Staphylococcus aureus, the two examined bacteria, both showed the establishment of growth inhibition zones in the disk diffusion assay. All samples were shown to be biocompatible by the cytotoxicity test conducted on the human normal fibroplast cell line (BJ1). In light of this, the cytotoxicity analysis demonstrated that the highest soda-lime-silica glass sample (SLP55), which has potential uses in the dental and bone fields, was entirely safe for use with the human normal fibroplast cell line (BJ1).

Modifications of silicate bioglass synthesis and composition for in vitro dissolution control: Static and dynamic assessment

Phosphate/Silicate Ratio Allows for Fine-Tuning of Bioactive Glass Crystallisation and Glass-Ceramic Microstructure

Preparation and Characterization of Low Temperature Heat-Treated 45S5 Bioactive Glass-Ceramic Analogues

Structure, biodegradation behavior and cytotoxicity of alkali-containing alkaline-earth phosphosilicate glasses

Sol-gel-synthesized bioglass-ceramics: physical, mechanical, and biological properties

Rational Design of Biofunctional Borosilicate Glasses: Tuning Therapeutic Ions and in Vitro Biological Evaluation

Dissolution of Glass–Ceramic Scaffolds of Bioactive Glasses 45S5 and S53P4

In Vitro Solubility and Bioactivity of Sr and Mg Co-Doped Calcium Phosphate Glass-Ceramics Derived from Different Heat-Treatment Temperatures

Comparative study of the structure and durability of commercial silicate glasses for food consumption and cosmetic packaging

Dissolution, bioactivity and osteogenic properties of composites based on polymer and silicate or borosilicate bioactive glass

Phase transformation and mechanical properties of new bioactive glass-ceramics derived from CaO-P2O5-Na2O-B2O3-SiO2 glass system

Non-linear dissolution mechanisms of sodium calcium phosphate glasses as a function of pH in various aqueous media

Crucial Chemical Revelations in 45S5 Bioactive Glass via Sequential Precursor Integration Order

The influence of time dependent Al2O3 dissolution during melting on the structure-bioactivity correlation of Mg containing silica-based bioactive glasses

Characterization, bioactivity, antibacterial and cytotoxicity of inexpensive soda-lime-silica glass/tetracalcium phosphate composites

The in vitro bioactive of sol–gel bioactive glass powders with three-dimensional lamellar structure

In vitro bioactivity evaluation, mechanical properties and microstructural characterization of Na₂O-CaO-B₂O₃-P₂O₅ glasses

Sol-Gel Synthesis, in vitro Behavior, and Human Bone Marrow-Derived Mesenchymal Stem Cell Differentiation and Proliferation of Bioactive Glass 58S

Atomistic insights into the mixed-alkali effect in phosphosilicate glasses

Dissolution of simulated nuclear waste glass at high surface area to solution volume, high pH and 70 °C: comparison of international simple glass and SON68 glass

Analysis and modelling of in vitro bioactivity for bioactive glass microspheres and granules in continuous fluid flow conditions