Abstract:The growing attention on plug-in electric vehicles, and the associated high-performance demands, have initiated a development trend towards highly efficient and compact on-board battery chargers. These isolated ac-dc converters are most commonly realized using two conversion stages, combining a non-isolated power factor correction (PFC) rectifier with an isolated dc-dc converter. This, however, involves two loss stages and a relatively high component count, limiting the achievable efficiency and power density and resulting in high costs. In this paper, a single-stage converter approach is analyzed to realize a single-phase ac-dc converter, combining all functionalities into one conversion stage and thus enabling a cost-effective efficiency and power density increase. The converter topology consists of a quasi-lossless synchronous rectifier followed by an isolated dual active bridge (DAB) dc-dc converter, putting a small filter capacitor in between. To show the performance potential of this bidirectional, isolated ac-dc converter, a comprehensive design procedure and multi-objective optimization with respect to efficiency and power density is presented, using detailed loss and volume models. The models and procedures are verified by a 3.7 kW hardware demonstrator, interfacing a 400 V dc-bus with the single-phase 230 V, 50 Hz utility grid. Measurement results indicate a state-of-the-art efficiency of 96.1% and power density of 2 kW/dm 3 , confirming the competitiveness of the investigated single-stage DAB ac-dc converter.

A Dual Active Bridge Converter With Multiphase Boost Interfaces for Single-Stage Bidirectional DC–AC Conversion

Single-Phase Isolated AC-AC Converters Based on the Dual Active Bridge Converter

Soft-Switching Single-Stage Current-Fed Full-Bridge Isolated Converter for High Power Ac/Dc Applications

A Dual-Active-Bridge-Based Novel Single-Stage Low Device Count DC–AC Converter

Double Y-Configuration Multi Active Bridge Converter: A Single Stage Bidirectional AC-DC Converter with Simple Sinusoidal Control

A Dual Active Bridge Converter Integrating Buck-Boost for Wide Voltage Range

A Dual-Transformer Based Hybrid Semi-Dual Active Bridge Converter for Wide Voltage Range Applications Utilizing Simple Segmented Control

A Hybrid ZVS Full-Bridge Converter with Transformer Winding Series-Parallel Auto Regulated Current Doubler Rectifier

A high-efficiency single-phase AC/DC converter with enabling window control and active input bridge

Parallel AC-Link Connection of Current-Fed Dual Active Bridge Converters

Control and Modulation of a Single-Phase AC/DC Converter with Smooth Bidirectional Mode Switching and Symmetrical Decoupling Voltage Compensation

An Improved Boost-Type Hybrid Converter with Multiple Outputs

Novel Bidirectional High-Frequency Isolated Direct AC/AC Converter with Unipolar Phase-Shifted Modulation Strategy

A Bidirectional Isolated Integrated AC–DC Converter Based on an Interleaved 3-Level T-Type Power Converters

Three-Phase Seven-level H-bridge Commutated Active Clamped Converter

Design and Optimization of an Efficient (96.1%) and Compact (2 kW/dm3) Bidirectional Isolated Single-Phase Dual Active Bridge AC-DC Converter

A Dual Half-Bridge Converter With Current Doubler Rectifier

High Step-Up/Down Switched-Capacitor Based Bidirectional DC-DC Converter

A Single-Stage Soft-Switched Isolated Three-Phase DC–AC Converter With Three-Phase Unfolder

A high light-load efficiency dual active bridge converter with split inductors