Abstract:Tensile strength is one of the most important mechanical parameters controlling the development of cracks in soil. However, it is frequently neglected in conventional geotechnical practice, because its magnitude is small and difficult to measure relative to other soil strength parameters. In this paper, a newly designed direct tensile test apparatus was employed to measure the tensile strength of an unsaturated clayey soil. A digital image acquisition and analysis system was developed for tensile strain analysis with the help of Particle Image Velocimetry (PIV) and Digital Image Correlation (DIC) techniques. Six groups of samples were compacted at a dry density of 1.7 Mg/m(3) and different water contents (6.5%, 8.5%, 10.5%, 12.5%, 16.5% and 20.5%). Test results show that the tensile strength characteristic curve (tensile strength versus water content) of the compacted unsaturated soil exhibits mono-peak feature. When water content is relatively low, the tensile strength increases with increasing water content and reaches the maximum value at a critical water content of about 9.3%. Then, it declines with further increase in water content. The evolution of tensile strength with water content depends on both suction and microstructure. Based on plotted tensile load-displacement curves, the tensile failure process can be divided into three typical stages which are: stress increasing stage (I), failure developing stage (II) and post-failure stage (III). It is found that the overall tensile failure process presents different patterns controlled by water content. Generally, the failure developing stage (II) lasts longer and the failure ductility is more pronounced when the sample is compacted at higher water content. Using PIV and DIC techniques, the development of displacement direction and strain concentration during tension can be well captured for appreciation of the soil failure mechanism. Based on the strain concentration information, the tensile fracture location and direction can be pre-determined for soil samples.

Observations on tensile testing of intact and slitted geotextiles through image analysis

Woven Geotextile Permeability under Uniaxial and Laterally Constrained Conditions

Prediction of Pore Size Characteristics of Woven Slit-Film Geotextiles Subjected to Tensile Strains

Analysis of Pore Size Distributions of Nonwoven Geotextiles Subjected to Unequal Biaxial Tensile Strains

Experimental Study on Water Permittivity of Woven Polypropylene Geotextile under Tension

Experimental study on pore sizecharacteristics of wovengeotextiles subjected to unequal biaxial tensilestrains

Influence of uniaxial tensile strain on filtration characteristics of geotextiles

Influence of Lateral Limited Uniaxial Tensile Strain on Opening Sizes

Analytical prediction and experimental research on pore size of nonwoven geotextiles under unconfined uniaxial tensile strain

Monitoring of the Variation in Pore Sizes of Woven Geotextiles with Uniaxial Tensile Strain

Investigation of Installation Damage on Warp Knit Type Geogrid Using Field Tests

The influence of uniaxial tensile strain on the equivalent opening sizes of nonwoven geotextiles

The Effect Of Pore Size Deformation On Multi-Pore Model Of Woven Geotextiles In Tension Test

Change of pore size of woven geotextiles affected by uniaxial tension using image analysis method

Effect of Testing Mechanisms on the Load-Strain-Time Behavior of Geosynthetic Reinforcements

Centrifuge modeling of the failure of geotextile-reinforced slopes

Analytical Study Of The Variation Of Pore Size Characteristics With Biaxial Tensile Strains On Woven Slit-Film Geotextiles

Tensile Strength of Clayey Soil and the Strain Analysis Based on Image Processing Techniques

Experimental Study on Deformation and Failure Mechanism of Geogrid-Reinforced Soil above Voids

Experimental study on behavior of interface between soil and geotextile

Numerical investigation of the tensile behaviors of needle-punched nonwoven geotextiles