Abstract:BACKGROUND: Alloying is a convenient and effective method to alter the microstructure and control the corrosion behavior of magnesium alloy.OBJECTIVE: To explore the in vitro and in vivo degradation of Mg-Nd-Zn-Zr alloy as a degradable medical biomaterial.METHODS:(1) In vitro static immersion test: The immersion tests were carried out at(37.0±0.5) ℃in a thermostatic bath. Six Mg-Nd-Zn-Zr alloy samples and six pure magnesium samples were immersed in the250 mL simulated body fluid and vibrated without agitation during immersion. After 3, 7 and 30 days static immersion, the samples were taken out from the simulated body fluid. Then the in vitro corrosion properties were evaluated using scanning electron microscope and energy dispersive spectrometer analysis.(2) In vivo animal experiment: After bone tunnel was established in the left femur of adult New Zealand rabbits, the Mg-Nd-Zn-Zr alloy rods were embedded in the Mg-Nd-Zn-Zr alloy group, titanium alloy rods were embedded in the titanium alloy group, and only bone tunnel was established in the sham-operated group. At 1, 2, 4, 8 weeks after implantation, an X-ray of the implanted region was taken to determine the location and the degradation behaviorof Mg-Nd-Zn-Zr alloy. At 4, 8 weeks after implantation, the corrosion product and its element composition were observed using scanning electron microscope with an energy dispersive spectroscopy system.RESULTS AND CONCLUSION:(1) The static immersion test showed that Mg-Nd-Zn-Zr alloy degraded slower than pure magnesium at each time point. It was obvious that there was a corrosion layer on the surface of Mg-Nd-Zn-Zr alloy after 30 days immersion in the simulated body fluid. Energy dispersive spectroscopy analysis revealed that these particles were mainly composed of oxygen, carbon, sodium, magnesium, calcium, phosphate and chlorine. After the corrosion products were removed, corrosion pits could be clearly seen on the surface of Mg-Nd-Zn-Zr alloy and pure magnesium. However, the corrosion pits on the surface of Mg-Nd-Zn-Zr alloy were smaller and more even than those on the surface of pure magnesium. This shows that the degradation modes of the Mg-Nd-Zn-Zr alloy and pure magnesium are distinctly different.(2) After implanted into the animals, the Mg-Nd-Zn-Zr alloy gradually degraded with time. And the corrosion products and ingredients were similar to the in vitro results.

The misalignment between degradation rate and mechanical integrity of Mg-Zn-Y-Nd alloy during the degradation evaluation in modified Hanks' solutions

Unrevealing the Intrinsically Electrochemical Mechanism on Degradation Behavior of Zn-Based and Mg-Based Alloys

In vitro and in vivo degradation of Mg-Nd-Zn-Zr alloy

In Vitro Degradation, Hemolysis And Mc3t3-E1 Cell Adhesion Of Biodegradable Mg-Zn Alloy

Degradation Behavior of Medical MgZZC-1 in Various Simulated Body Fluids

Research Progress in Degradation Behavior of Biodegradable Medical Mg-based Alloys in Vivo and in Vitro

Mechanical properties, biodegradability and cytocompatibility of biodegradable Mg-Zn-Zr-Nd/Y alloys

The Influence of Yttrium and Manganese Additions on the Degradation and Biocompatibility of Magnesium-Zinc-based Alloys: in Vitro and in Vivo Studies

Optimizing Mechanical Property and Cytocompatibility of the Biodegradable Mg-Zn-Y-Nd Alloy by Hot Extrusion and Heat Treatment

Mechanical properties and corrosion behaviors of Mg−4Zn−0.2Mn−0.2Ca alloy after long term in vitro degradation

Evaluation on the corrosion resistance, antibacterial property and osteogenic activity of biodegradable Mg-Ca and Mg-Ca-Zn-Ag alloys

Comparison of Biodegradable Behaviors of AZ31 and Mg–Nd–Zn–Zr Alloys in Hank's Physiological Solution

Microstructure, Mechanical Property, in Vitro Biodegradation Behavior and Biocompatibility of As-Extruded Mg-2Zn-0.2Zr-xNd (x = 0.2, 0.6, 1.0) Alloys

In Vitro Degradation Behavior and Cytocompatibility of Mg-6Zn-Mn Alloy

In Vitro Degradation and Biocompatibility of Mg-Nd-Zn-Zr Alloy

Microstructure, Mechanical Properties, in Vitro Degradation and Cytotoxicity of Mg-4zn-3ha Alloy for Biodegradable Implant Materials

Effects of thermomechanical processing on microstructures, mechanical properties, and biodegradation behaviour of dilute Zn-Mg alloys

Mechanical Properties, Degradation Performance and Cytotoxicity of Mg–Zn–Ca Biomedical Alloys with Different Compositions

Predicting the Degradation Behavior of Magnesium Alloys with a Diffusion-Based Theoretical Model and in Vitro Corrosion Testing

In Vitro Study on Mg-Sn-Mn Alloy As Biodegradable Metals

Evaluation of the Biodegradation Product Layer on Mg-1Zn Alloy During Dynamical Strain