Abstract:The mechanical and deformation behaviors of the surrounding rock play a crucial role in the structural safety and stability of tunnel shafts. During drilling and blasting construction, seepage failure and hard brittleness damage of the surrounding rock occur frequently. However, previous discussions on stress deformation in the surrounding rock did not consider these two factors. This paper adopts the theory of elastoplastic to analyze the effects of seepage and hard brittleness damage on the stress and deformation of the surrounding rock of a tunnel shaft. The seepage effect is equivalent to the volumetric force, and a mechanical model of the surrounding rock considering seepage and hard brittleness damage was established. An elastoplastic analytical formula for surrounding rock was derived, and its rationality was verified through numerical examples. Based on these findings, this study revealed the plastic zone as well as stress and deformation laws governing the behavior of surrounding rock. The results showed that the radius of a plastic zone had a significant increase under high geostress conditions, considering the hard brittleness damage characteristics of the surrounding rock. The radius of the plastic zone increased with an increase in the initial water pressure and pore pressure coefficient, and the radius of the plastic zone increased by 5.5% and 3.8% for each 0.2 MPa increase in initial water pressure and 0.2 increase in pore pressure coefficient, respectively. Comparing the significant effects of various factors on the radius of the plastic zone, the effect of support resistance inhibition was the most significant, the effect of the seepage parameter promotion was the second, and the effect of the hard brittleness index promotion was relatively poor. The hard brittleness index and water pressure parameters were positively correlated with the tangential and radial stresses in the surrounding rock, and the radial stresses were overall smaller than the tangential stresses. The deformation of the surrounding rock was twice as large as the initial one when hard brittleness damage and seepage acted together. These findings can provide a reference for the stability evaluation of the surrounding rock in tunnel shafts.

SIMULATION OF DEFORMATION AND FAILURE OF SURROUNDING ROCK MASSES OF UNDERGROUND CAVERN IN LOW GROUND STRESS REGIONS WITH FINITE ELEMENT METHOD

Mechanical Analysis of Small Interval Tunnel Based on Three-dimensional FEM Model

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

Numerical Modeling Analysis for Surrounding Rockmass Stability of Large Underground Cavities

Stability Analysis of Jointed Rock Mass in Large Underground Caverns Based on Multi-Scale Analysis Method

3D NUMERICAL MODELING OF POSSIBLE FAILURE ZONE WITH UNDERGROUND EXCAVATION

Sensitivity Analysis of the Influences of Rock Mechanical Parameters on the Deformation of Underground Caverns

Deformation and Stability Analysis of Surrounding Rock Mass in Deep Underground Cavern Based on Microseismic monitoring and Numerical Modelling

Study the anisotropic behavior of layered surrounding rock based on 3D FDEM method

Numerical Simulation of the Stability of Rock Mass around Large Underground Cavern

Analysis of Extent of Deformation Range and Failure Characteristics of Rocks Surrounding a Tunnel Crossing Fault Zone Based on FDEM

Failure mechanism and deformation prediction of soft rock tunnels based on a combined finite–discrete element numerical method

Deformation and Failure Mechanism of Surrounding Rock in Deep Soft Rock Tunnels Considering Rock Rheology and Different Strength Criteria

Stability Analysis of Surrounding Rock in Deep Underground Engineering Under Fluid-solid Interaction

Deformation and Failure Mechanism Exploration of Surrounding Rock in Huge Underground Cavern

Failure Behaviors and Rock Deformation During Excavation of Underground Cavern Group for Jinping I Hydropower Station

A novel anisotropic deterioration mechanical model for rock ductile–brittle failure under 3D high-stress and its application

Finite Element Method Regression Back Analysis of Initial Stress Field in a Large Underground Chamber Area

Application of numerical analysis principles and key technology for high fidelity simulation to 3-D physical model tests for underground caverns

Deformation and Stress of Rock Masses Surrounding a Tunnel Shaft Considering Seepage and Hard Brittleness Damage

Theory and Numerical Simulation of Deep Rock Mass Based on a Non-Euclidean Model