Characteristics of electrical treeing in extruded polypropylene and cross-linked polyethylene cable insulation

Jorunn Holto,Erling Ildstad,Ingeborg Lunde

DOI: https://doi.org/10.1109/ichve.2012.6357059

2012-09-01

Abstract:This paper presents results from experimental investigations performed in order to characterize and compare electrical tree formation in extruded syndiotactic polypropylene (s-PP) and cross-linked polyethylene (XLPE) cable insulation. All tests were performed using molded needle-plate samples with an insulation distance of 1.05 mm. Initiation and formation of electrical trees from the needle tips were studied using partial discharge measurements and optical microscopy video techniques. The tree growth was characterized by measuring length and width of the trees, the time needed for the first branch to reach the opposite ground electrode and time to electric breakdown. The effect of different AC voltages, with magnitudes up to 12 kV and frequencies in the range of 50–1000 Hz, were examined. In XLPE electrical trees were found to develop in a stepwise manner, with high degree of branching associated with high partial discharge (PD) activity. Electric breakdown typically occurred when the first tree tip reached the ground electrode. In s-PP the initial degree of branching was relatively low, without detectable partial discharge activity. Typically several parallel branches had to reach the ground electrode before breakdown occurred. At increasing frequencies the tree width and degree of branching was found to increase. Meanwhile the time until the first tree branch reached the ground electrode and the time to breakdown was found to decrease with increasing frequency above 300 Hz. These observations are in agreement with the proposed RC-model of an electric tree, which implies that the voltage distributed along the tree channel increase with frequency. Thus the likelihood of partial discharges along the existing tree length will also increase with the frequency of the applied voltage.