Abstract:Large-diameter monopiles are the predominant foundation solution for supporting offshore wind turbines. They are conventionally designed using soil reaction curves developed for long slender piles used for supporting offshore oil and gas platforms (e.g., the API p-y model). However, due to the difference in the length/diameter ratio and the resulting soil mechanisms, the use of p-y curves alone can lead to significant under-prediction of the lateral stiffness and capacity of monopiles. To overcome the shortcoming, the authors have previously proposed a conceptual two-spring framework, i.e., the so-called 'p-y + M-R-theta(R)' model, to capture the monopile response in soft clay under lateral loading. The framework uses distributed p-y springs to consider the lateral soil resistance along the pile above the rotation point (RP) and a single moment-rotation (M-R-theta(R)) spring attached at the RP to capture the entire soil resistance below the RP, i.e., the distributed resistance along the pile, base shear and base moment at the pile tip. The proposed p-y and M-R-theta(R) springs were curve-fitted to the results of 3D numerical analyses. However, as the stress-strain response and the shear strength profile inevitably influence the p-y and M-R-theta(R) springs, the applicability of the empirical formulations to soil conditions other than those examined is uncertain. This study proposes an enhancement to the 'p-y + M-R-theta(R)' framework, in which the p-y and M-R-theta(R) springs are not tied to a specific soil and strength profile but fundamentally linked to the properties that can be measured directly in the site investigation and laboratory. This extension is achieved through analytical analyses and an extensive parametric numerical study. The predictive capabilities of the model are demonstrated by back-analyses of finite element analyses and centrifuge model tests. The proposed model provides practising engineers with a simple yet powerful approach to use site-specific soil reaction curves in the design of monopiles embedded in soft clay.

Evaluation of post-storm soil stiffness degradation effects on the performance of monopile-supported offshore wind turbines in clay

Lateral Cyclic Pile–soil Interaction Studies on a Rigid Model Monopile

Centrifuge Modelling for Seismic Response of Single Pile for Wind Turbine Subjected to Lateral Load

DETERMINATION ON CRITICAL DEPTH OF MONOPILE IN SAND UNDER CYCLIC HORIZONTAL LOAD

A Numerical Study on the Lateral Loading Behaviour of Offshore Tetrapod Piled Jacket Foundations in Clay

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Cyclic Response of Laterally Loaded Pile after Storm Loading

Model Tests on the Long-Term Dynamic Performance of Offshore Wind Turbines Founded on Monopiles in Sand

Numerical Simulation of Offshore Monopiles with Reinforcement in Shallow Soil Layer

Centrifuge Modeling of the Cyclic Lateral Behavior of Large-Diameter Monopiles in Soft Clay: Effects of Episodic Cycling and Reconsolidation

Offshore Wind Turbine Monopiles under Real Wind and Wave Conditions: Considering Cyclic Softening of Clays

Dynamic response analysis of monopile offshore wind turbines to seismic and environmental loading considering the stiffness degradation of clay

Numerical Analysis of the Long-Term Performance of Offshore Wind Turbines Supported by Monopiles

Dynamic Response of Offshore Open-Ended Pile under Lateral Cyclic Loadings

Influence of Pile Diameter and Aspect Ratio on the Lateral Response of Monopiles in Sand with Different Relative Densities

Site-specific soil reaction model for monopiles in soft clay based on laboratory element stress-strain curves

Dynamic model test on monopile for offshore wind turbine under jointed lateral environmental load and seismic load

Fatigue Life Analysis of Monopile-Supported Offshore Wind Turbines Based on Hyperplastic Ratcheting Model

Lateral static stiffness of offshore monopile socketed in soft rock

A Unified Lateral Soil Reaction Model for Monopiles in Soft Clay Considering Various Length-to-diameter (L/D) Ratios

Influence of Precast Microbial Reinforcement on Lateral Responses of Monopiles