Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Ultra-low lattice thermal conductivity and high figure-of -merit in Cl and K co-dopped Bi2Se3 prepared by KCl flux

Ultralow Lattice Thermal Conductivity and Improved Thermoelectric Performance in Cl-Doped Bi2Te3- xSex Alloys

Band Structure Engineering of Bi<sub>4</sub>O<sub>4</sub>SeCl<sub>2</sub> for Thermoelectric Applications

Multiple Converged Conduction Bands in K2bi8se13: A Promising Thermoelectric Material with Extremely Low Thermal Conductivity

Dual‐Site Doping and Low‐Angle Grain Boundaries Lead to High Thermoelectric Performance in N‐Type Bi2S3

Intrinsically Low Thermal Conductivity In Bisbse3: A Promising Thermoelectric Material With Multiple Conduction Bands

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Enhanced Thermoelectric Properties of Cu3SbSe4 Compounds by Isovalent Bismuth Doping

Ultralow Lattice Thermal Conductivity and High ZT Beyond 1 Realized in Bi2S3 Nanocomposites via Bottom‐Up Structure Design

Electrical property enhancement and lattice thermal conductivity reduction of n-type Mg3Sb1.5Bi0.5-based Zintl compound by In&Se co-doping

Enhanced Thermoelectric Performance of N-Type Bi2o2se by Cl-Doping at Se Site

Enhanced Thermoelectric Properties in Highly Co-Doped Bi2Se3 by Density-of-State Effective Mass Increase

Ultralow lattice thermal conductivity and enhanced power generation efficiency realized in Bi2Te2.7Se0.3/Bi2S3 nanocomposites

Realizing High Thermoelectric Performance in Earth‐Abundant Bi 2 S 3 Bulk Materials via Halogen Acid Modulation

High Thermoelectric Performance in Cu-Doped Bi 2 Te 2.7 Se 0.33 Due to Cl Doping and Multiscale AgBiSe 2

Promoted thermoelectric performance of (Ag, Na) co-doped polycrystalline BiSe by optimizing the thermal and electrical transports simultaneously

Ultralow Lattice Thermal Conductivity and Superhigh Thermoelectric Figure‐of‐Merit in (Mg, Bi) Co‐Doped GeTe

High thermoelectric properties in polycrystalline SnSe materials realized by rare earth halide Co-doping

Unlocking the Potential of Cu3SbSe3: Ultralow Thermal Conductivity and Enhanced Thermoelectric Performance

Ultralow Thermal Conductivity of a Chalcogenide System Pt3Bi4Q9 (Q = S, Se) Driven by the Hierarchy of Rigid [Pt6Q12]12- Clusters Embedded in Soft Bi-Q Sublattice

Expand band gap and suppress bipolar excitation to optimize thermoelectric performance of Bi0.35Sb1.65Te3 sintered materials